Wio Terminal Chassis - module with 650mAh battery for Wio Terminal

Module with OLED 0.96" display with a resolution of 128x64 px. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 104030008

Module with FM receiver, with its help it is possible to receive radio waves broadcast in the FM band (frequency 50-115MHz). The module has been equipped with a 3,5mm jack socket, through which you can connect headphones. The module has a connector in accordance with the Grove standard. Seeed Studio 107020006

Module with pressure and temperature sensor BMP280. The board is equipped with a Grove connector and communicates via the I2C or SPI interface. Seeed Studio 101020192

Module with humidity and air temperature sensor based on the AM2302 system. It allows temperature measurement in the range from -40 to 80 ° C and the humidity measurement takes place in the range of 5 to 99% RH. The module has a connector in accordance with the Grove standard. Seeed Studio 101020019

A small module - an infrared emitter (LED IR). The diode emits infrared light with a wavelength of 940 nm. With the help of the module, it is possible to transmit commands or signals that can be received by an infrared receiver. The transmission range is up to 10 meters. Seeed studio 101020026

Module with digital light sensor TSL2561. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020030

Module with 4-digit 7-segment display with red digits. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020044

A small servo (23 x 11.5 x 24 mm) with a weight of 8.6 g, power supply 4.8-6V, maximum torque 1.8 kg / cm (at 6V). It has a connector compatible with the Grove standard. Seeed Studio 316010005

MH-Z16 carbon dioxide sensor with Grove connector. It communicates via the UART interface. Seeed Studio 101020067

Speech recognition module with Nuvoton ISD9160 system, microphone, Flash memory and speaker output. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 101020232

Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029

Module with a reflection sensor (line sensor) RS-06WD. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020172

The module allows the detection of volatile organic compounds (VOC) in the air, based on Winsen\'s WSP2110 system. Allows for detection in the air; formaldehyde (HCHO), methane, benzene, toluene, alcohol, etc. The sensor output is an analog signal. Seeed studio 101020001

Module with LoRa transmitter based on RFM95 (SX1276 LoRa®). It works with a frequency of 433 MHz, maximum power up to 100 mW and a power gain of up to + 20dBm. The module has a built-in antenna, but it is possible to connect an external antenna (MHF connector). The module has a connector in accordance with the Grove standard. Seeed studio 113060007

Module with a pulse sensor (heart rate). The board is equipped with a Grove connector and a digital output in the form of pulses. Seeed Studio 101020033

Base Shield V2 is an extension for tiles with an Arduino shield connector, it has a Grove connector, which can be connected to Grove-compatible modules / sensors. Seeedstudio 103030000