Recorder v3.0 - Grove module
ID: 566554
5906623414314
zł60.82
Tax included
zł49.45 tax excl.
Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029
Description
Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set includes a small loudspeaker on which the recorded sound can be played.
The module can work independently.
The module is operated with a single button. Holding it down for 2 seconds will start recording. A short press of the button will play the recorded sounds. You can also control the module from the microcontroller level (using the digital inputs of the module). To be able to control the module from the microcontroller level (eg Arduino ), the REC slide switch must be in the ON position. The module has a connector in accordance with the Grove standard.
The module can be used with the Base Shield V2 - shield extension with Grove connectors for Arduino
properties
- Allows you to record and play sounds
- Maximum recording time: 83 seconds
- Based on the ISD9160FI chip
- Possible control via a button (operation in standalone mode) or using a microcontroller (digital inputs)
- Built-in microphone
- A small speaker attached to the set
- Operating temperature range: 0-85 ℃
- Supply voltage: 3.3 / 5V
- Dimensions: 40 x 20 mm
- Weight: 31.5 g
Included
- Recorder v3.0 - Grove module
- Speaker
- The cable is compatible with the Grove system
566554
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
WAV files player module. It is based on a DAC converter and an audio amplifier, there is a 3.5 mm audio output on the board. The files are played from the microSD card. Adafruit 94
zł163.39
24h
Available quantity: 1
Available
A small module with a temperature sensor (thermistor). As the temperature changes, the resistance of the thermistor changes, which allows the temperature to be measured in the range from -40 to 125 ° C with an accuracy of 1.5 ° C. The module has a connector in accordance with the Grove standard. Seeed studio 101020015
zł15.36
24h
Available quantity: 2
Available
A small module with a PIR motion sensor. It allows detecting movement within a maximum range of 6 meters (default up to 3 meters). The measuring angle is 120 degrees. The module has a connector in accordance with the Grove standard. Seeed Studio 101020020
zł49.90
24h
Available quantity: 3
Available
Module with a flame sensor or other light sources with a wavelength in the range of 760 to 1100 nm. It was based on the YG1006 sensor (photovolver NPN). The sensor has a connector compatible with the Grove standard. Seeed studio 101020049
zł38.14
24h
Available quantity: 2
Available
The module allows the detection of volatile organic compounds (VOC) in the air, based on Winsen\'s WSP2110 system. Allows for detection in the air; formaldehyde (HCHO), methane, benzene, toluene, alcohol, etc. The sensor output is an analog signal. Seeed studio 101020001
zł79.32
24h
Available quantity: 4
Available
LM386 audio amplifier module. It is supplied with the voltage ranging from 4 to 12 V. The set includes an 8 Ω, 0.5 W loudspeaker. DFRobot DFR0064
zł61.97
24h
Available quantity: 1
Available
Other products in the same category (9)
Module for recording sounds, which can store recordings up to 20 seconds. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 107020007
zł37.82
24h
Available quantity: 2
Available
This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381
zł131.84
24h
Available quantity: 1
Available
Audio player and recorder with built-in VS1003 codec, 3.5 mm jack audio output and a microphone
zł34.21
24h
Available quantity: 2
Available
Gravity: Voice Recorder Module is a sound recording module powered by 5V voltage. It can store sounds up to 10 seconds long. DFRobot SEN0197
zł26.24
24h
Available quantity: 1
Available
Sound recording module that can store sounds up to 40 minutes long. It allows you to download the recordings to a computer via USB type C. DFRobot DFR0745
zł33.06
24h
Available quantity: 2
Available
Audio module with WM8960 stereo codec. It allows you to record sounds and play them. Waveshare 15019
zł60.29
24h
Available quantity: 8
Available
Sound recording module with I2C interface. It can store sounds up to 100 seconds long. DFRobot SEN0197
zł47.26
24h
Available quantity: 5
Available
Audio recorder module that allows for multiple recording and playback of sounds. Comes with a loudspeaker
zł11.86
24h
Available quantity: 4
Available
The Spectrum Shield enables your Arduino with the capability of splitting a stereo audio input into 7-bands per channel. You can then read the amplitude of each channel using the ADC on your Arduino allowing you to control everything from LEDs to motors, pumps to relays, or even fire, all with sound. DEV-13116
zł149.36
24h
Available quantity: 1
Available
Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029