ISD1820 - audio recorder module + speaker

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

The Spectrum Shield enables your Arduino with the capability of splitting a stereo audio input into 7-bands per channel. You can then read the amplitude of each channel using the ADC on your Arduino allowing you to control everything from LEDs to motors, pumps to relays, or even fire, all with sound. DEV-13116

Gravity: Voice Recorder Module is a sound recording module powered by 5V voltage. It can store sounds up to 10 seconds long. DFRobot SEN0197

Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029

Audio module with WM8960 stereo codec. It allows you to record sounds and play them. Waveshare 15019

Module for recording sounds, which can store recordings up to 20 seconds. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 107020007

Sound recording module that can store sounds up to 40 minutes long. It allows you to download the recordings to a computer via USB type C. DFRobot DFR0745

Audio recorder module that allows for multiple recording and playback of sounds. Comes with a loudspeaker

Audio player and recorder with built-in VS1003 codec, 3.5 mm jack audio output and a microphone

Sound recording module with I2C interface. It can store sounds up to 100 seconds long. DFRobot SEN0197