Audio Codec Module with WM8960 - Waveshare 15019
ID: 573152
5906623465606
zł60.29
Tax included
zł49.02 tax excl.
Audio module with WM8960 stereo codec. It allows you to record sounds and play them. Waveshare 15019
Description
Audio module with WM8960 stereo codec. It allows you to record sounds and play them. The board has a built-in MEMS microphone and a 3.5 mm connector to connect external headphones. Communication with the module can take place via the I2C (control) interface and I2S (audio).
properties
- Codec: WM8960
- Control interface: I2C
- Audio interface: I2S
- Audio format: WAV
- DAC signal noise ratio: 98 dB
- ADC signal interference factor: 94dB
- Headphone driver: 40 mW (16Ω to 3.3V)
- Speaker driver: 1 W per channel (8 Ω BTL)
- Audio sampling frequencies 8 / 11,025 / 22.05 / 44.1 / 48KHz
- Operating voltage: 3.3 V
573152
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Pmod I2S2 is a module with 24-bit A / C and D / C audio converters derived from standard 3,5 mm Jack connectors. Thanks to them, it is possible to send and receive stereo audio signals using the I2S protocol. Digilent 410-379
zł131.61
24h
Available quantity: 5
Available
LM386 audio amplifier module. It is supplied with the voltage ranging from 4 to 12 V. The set includes an 8 Ω, 0.5 W loudspeaker. DFRobot DFR0064
zł61.97
24h
Available quantity: 1
Available
Other products in the same category (9)
Audio player and recorder with built-in VS1003 codec, 3.5 mm jack audio output and a microphone
zł34.21
24h
Available quantity: 2
Available
Gravity: Voice Recorder Module is a sound recording module powered by 5V voltage. It can store sounds up to 10 seconds long. DFRobot SEN0197
zł26.24
24h
Available quantity: 1
Available
Sound recording module that can store sounds up to 40 minutes long. It allows you to download the recordings to a computer via USB type C. DFRobot DFR0745
zł33.06
24h
Available quantity: 2
Available
The Spectrum Shield enables your Arduino with the capability of splitting a stereo audio input into 7-bands per channel. You can then read the amplitude of each channel using the ADC on your Arduino allowing you to control everything from LEDs to motors, pumps to relays, or even fire, all with sound. DEV-13116
zł149.36
24h
Available quantity: 1
Available
Module for recording sounds, which can store recordings up to 20 seconds. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 107020007
zł37.82
24h
Available quantity: 2
Available
Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029
zł60.82
24h
Available quantity: 2
Available
Sound recording module with I2C interface. It can store sounds up to 100 seconds long. DFRobot SEN0197
zł47.26
24h
Available quantity: 5
Available
Audio recorder module that allows for multiple recording and playback of sounds. Comes with a loudspeaker
zł11.86
24h
Available quantity: 4
Available
This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381
zł131.84
24h
Available quantity: 1
Available
Audio module with WM8960 stereo codec. It allows you to record sounds and play them. Waveshare 15019