

Wireless data transmission module that can operate in the 433 MHz frequency band. The maximum transmitting power of the module is 27 dBm and can transmit data up to 500 m in open space. There is a pin on the board that allows you to connect an external antenna. The module is powered with the voltage of 12 V and communicates via a single-wire digital interface.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Pin header goldpin black 1x40 pins. Straight connector for through-hole assembly. 2.54mm pitch.
Feather board will let you integrate packetized radio (with the RFM69 radio) or LoRa radio (with the RFM9x\'s). These radios are good options for kilometer-range radio, and paired with one of our WiFi, cellular or Bluetooth Feathers, will let you bridge from 433/900MHz to the Internet or your mobile device. Adafruit 3230
A set of 40 pieces of female-female connecting cables in various colors, 10 cm long
A set of 40 pcs of male-female connecting cables in various colors, 10 cm long
A set of 40 pcs of male-male connecting cables in various colors, 10 cm long
The NRF24L01+ chip module for radio communication, which operates in the 2.4 GHz ISM band. It is used in various applications such as wireless sensors, remote control, wireless networks. It supports the Enhanced ShockBurst protocol, which provides automatic packet handling. It communicates via an SPI interface
Adapter with 3.3V voltage regulator designed for NRF24L01 modules with 8-pin connector
Long-range Sub-GHz wireless RF transmitter and receiver module, capable of operating in the 868 MHz frequency band. The integrated architecture allows the use of a minimum number of external components while maintaining maximum design flexibility. Hoperf RFM22B-868S2
The FS1000A transmitter and the MX-RM-5V receiver enable communication in the ISM band; they are easy to use, do not require advanced bus control and have very small dimensions. Especially recommended for work with Arduino and STM32
Radio module with RFM69HCW 433 MHz chip, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4073
The NRF24L01+ chip module for radio communication, which operates in the 2.4 GHz ISM band. It is used in various applications such as wireless sensors, remote control, wireless networks. It supports the Enhanced ShockBurst protocol, which provides automatic packet handling. It communicates via an SPI interface
A wireless transceiver operating in the 434 MHz band based on the RFM69HCW system. Maximum power: 100mW; bit rate up to 300kbps. Range in the open space reaches up to 500m. The module communicates using the SPI bus. Compatible with Arduino
A GFSK transceiver operating in the ISM 2400 ... 2483.5 MHz frequency range. Powered by a voltage of 1.9 ... 3.6 V, the pins are goldpin connectors. It has a built-in PCB antenna. HOPE MICROELECTRONICS RFM75-S
A long-range RF sub-GHz wireless transceiver module capable of operating in the 433 MHz frequency band. The integrated architecture allows the use of a minimum number of external components with maximum design flexibility. RFM69HW433
No product available!
Radio receiver module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0142
HAT module with RFM95W 433 MHz system for LoRa / LoRaWAN communication and OLED display, designed for Raspberry Pi minicomputers. Adafruit 4075
2.4 GHz RF module with nRF24L01+ chip. The module has an RP-SMA connector with reverse polarity, allowing the connection of an external antenna. The system has a built-in 3.3 V stabilizer and IO lines with a tolerance of 5 V. SparkFun WRL-00705
The module enables remote control of four independent devices using the 433 MHz band. Simple configuration of operating modes and the ability to tune the receiver make the set suitable for automation, lighting systems, and remote control of devices.
DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112
Long-range Sub-GHz wireless RF transmitter and receiver module, capable of operating in the 868 MHz frequency band. The integrated architecture allows the use of a minimum number of external components while maintaining maximum design flexibility. Hoperf RFM69HW-868S
Wireless data transmission module operating at 433 MHz. It is powered with the voltage of 12 V