1 Channel USB Powered Solid State Relay Module - module with SSR DC relay and USB communication

Module with one 240V/2A relay controlled by 5V with a fuse triggered by a high state. modSSR-1CH-H

This XIAO ESP32-C6-based relay module is designed for intelligent automation. It allows independent control of six channels via Wi-Fi, Zigbee, Thread, or BLE, and thanks to the built-in ESPHome, it easily integrates with Home Assistant. It supports DC devices up to 30V, features two Grove ports for expansion, and comes in an aesthetically pleasing PLA enclosure. Ideal for IoT systems, home automation, lighting, and motor control. Seeed Studio 114993588

The module offers 16 TTL-compatible GPIOs, 10 analog channels and individual I/O configuration, making it ideal for automation, DIY projects and advanced system engineering, with the possibility of remote control via standard network interfaces. Numato Lab NLETHGC016-HA

Module with 8 digital inputs and 4 relays with a maximum switching current of 2 A. It communicates via the RS485 interface and supports the Modbus RTU protocol. The board is enclosed in an industrial housing. Wellpro WP8024ADAM

A compact relay module with an Omron G5LE-14-DC5 relay, capable of controlling loads up to 10 A with a 5 V coil voltage. Thanks to a BSS138K MOSFET transistor, it can be activated by a 2.5 V to 20 V logic signal, facilitating interoperability with microcontrollers. The module is equipped with 5 mm screw terminals, a 3-pin JST SH connector, and LEDs to indicate operation. Pololu 5662

The module is equipped with three 5A / 250VAC relays controlled by digital outputs. Relay contacts are led out to ARK screw terminals. Designed to work with NVIDIA Jetson Nano. Waveshare 3-CH Relay for Jetson Nano

Module with 8 SSR relays with a load of up to 3 A. The board communicates via the Ethernet interface. Numato Lab 8ETHSSR001-DC

Module with 5 V relay with a maximum switching current of 2 A. It communicates via the USB interface and does not require an additional power supply. Numato Lab USBPOWRL002

Module with 4 relays with a maximum switching current of 7 A. Equipped with the ATmega328P microcontroller, it can be programmed in the Arduino IDE. Numato Lab PRLY002

Module with SSR M281 relay with a load of up to 1 A. The board is equipped with a Grove connector and is controlled by a digital input. Seeed Studio 101020603

4 Channel 5V Relay Module

Module with four 240V/2A relays controlled by 5V with a fuse triggered by a high state. modSSR-4CH-H

The module is equipped with eight 10A / 250VAC relays controlled independently via a serial bus (UART) or from a PC (through a microUSB connector). The NO / NC contacts of the relays have been led to the ARK screw terminals. The board recommended for use with Arduino enables the control of eight relays using only two microcontroller lines. ICSTATION ICSE014A

Crowtail-MOSFET 2.0 enables controlling devices powered with up to 50 V DC using a low-voltage signal from a microcontroller. It is used in projects requiring power isolation or switching, such as fans, LED strips or DC motors.

Module with 16 relays and 8 analog inputs. Communicates via the WiFi wireless interface. Numato Lab WFRL160001

Numato Lab NLETHGC032-HT is a versatile 32-channel GPIO Ethernet module, ideal for advanced automation projects and expansion of electronic systems.