Modbus RTU Relay 32CH - module with 32 relays and RS485 interface

Module with 8 SSR relays with a load of up to 3 A. The board communicates via the Ethernet interface. Numato Lab 8ETHSSR001-DC

Module with 8 relays SSR G3MC202P with a load up to 2 A. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 103020136

2-channel module with relays designed to work with the Raspberry Pi Pico. It can switch signals up to 120 V AC or 24 V DC and currents up to 2 A. SB Components 21376

Module with 8 SSR relays with a load of up to 3 A. The board is equipped with the ULN2003 system and communicates via a digital interface. Numato Lab SSRC80001-AC

The module with the relay is designed for the M5Stack sets. It allows you to control devices with a working voltage of up to 220 V AC and a current of up to 3 A or a voltage of 30 V DC and an intensity of 3 A. M5Stack U023

Module with 4 5 V relays with a maximum switching current of 2 A. It communicates via the USB interface and does not require an additional power supply. Numato Lab USBPOWRL004

Module with MOSFET transistor, 5-36 V, 20 A, switching frequency 1 kHz. DFRobot DFR0457

The module is equipped with eight 10A / 250VAC relays controlled independently via a serial bus (UART) or from a PC (through a microUSB connector). The NO / NC contacts of the relays have been led to the ARK screw terminals. The board recommended for use with Arduino enables the control of eight relays using only two microcontroller lines. ICSTATION ICSE014A

8-channel PoE module with relays allowing you to connect your PC to other electronic circuits via the network. It does not need a separate cable for power and data transmission. It can be controlled via a simple web interface or Telnet. Numato Lab NLRP1001-A

The module contains four 5V relays with a maximum current of 10A (250 VAC) and opto-isolated inputs, and with jumpers it is possible to select switching with high or low status. The module is equipped with screw connectors. modRL04_ISO

Module with 8 relays with a voltage of 12 V and a load of up to 10 A. The board communicates via the Ethernet interface. Numato Lab 8ETHRL001

I/O module supporting Modbus RTU via USB and RS485 and Modbus TCP via Ethernet. It has 4 built-in SPST relays and 8 digital inputs, 8 digital outputs and 4 analog inputs. Provides a flexible DIN rail mounting system. Numato Lab NLRXE002-A

Module with 2 SSR relays with a load of up to 3 A. The board communicates via the USB interface. Numato Lab SSR20001-DC

Switch module with a maximum voltage of 12 V and a current of 10 A based on a MOSFET transistor, controlled by a digital pin. It is equipped with a screw connection and a status LED. SparkFun SPX-19799

Module with one 240V/2A relay controlled by 5V with a fuse triggered by a high state. modSSR-1CH-H

2-channel module with 12V relays and a radio receiver in a set with a remote control operating at 433 MHz