Categories - Official Raspberry Pi distributor

New products

Dual TB9051FTG Motor Driver - dual DC motor driver for Arduino

Dual DC motor controller designed for Arduino, which enables the motor to be supplied with voltage in the 4.5 ... 28V range and power consumption in continuous operation of 2.6 A (5A at the top) of two DC motors. Polol 2520

More details

ID: 572195

16,53€ gross (23% VAT)
13,44€ net

Add to wishlist

Data sheet

Output current2,6 V
Number of channels2
Supply voltage min4,5 V
Supply voltages max28 V

More info


Universal dual DC motor controller designed for Arduino . The controller can be used for motors supplied with voltage in the 4.5 ... 28 V range and for power consumption in continuous operation of 2.6 A (5 A in peak) of two DC motors. The controller is protected by overheating and overcurrent and has reverse voltage protection. The motors are controlled using a PWM signal with a frequency up to 20 kHz.


  • Two single H-bridges (TB9051FTG chip)
  • Supply voltage for motors: 4.5 ... 28 V
  • Maximum power consumption: 2.6 A (5 A at peak)
  • PWM signal frequency up to 20 kHz
  • Protection against overheating and system overload
  • Reverse protection circuit
  • The automatic step-stop mode prevents the system from overheating during sudden braking
  • It is possible to use D24V5F9 or S10V3F9 inverters as the power source
  • Dimensions: 48 x 51 x 7.6 mm
  • Weight: 11 g


  • Dual TB9051FTG Motor Driver Shield for Arduino extension
  • 1 x extended 10-pin female connector
  • 2 x 8-pin female extension connector
  • 2 x extended female connector 6-pin
  • 3 x 2-pin screw connector
  • 25-pin male connector
  • jumper