Mini GPS Shield - adapter for the GPS receiver for Arduino Mini

4inch Touch LCD Shield for Arduino is an overlay with a 4-inch LCD display. The screen has a resolution of 480x320 pixels. Communication with the display is via the SPI interface. Waveshare 4inch TFT Touch Shield

(DFR0144) Relay Shield for Arduino V2.1

Controller module dedicated to Arduino boards. Equipped with 4 buttons, a two-axis joystick and an Xbee connector. DFRobot DFR0008

DEV-14352

Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265

Extension module (shield) with a signal generator for Arduino Pro Mini. It can trigger a sine, square or triangle waveform up to 3MHz. SparkFun BOB-11420

This shield allows you to interface Wixel wireless modules to your Arduino (and other compatible products), enabling simple wireless programming, debugging, and control using standard Arduino software. Pololu 2513

Shield for Arduino containing the most commonly used peripherals in an easy-to-use form. It is equipped with: OLED display, RGB diode, buttons, temperature and humidity sensor and joystick. DFRobot DFR0270

Expansion module with a joystick and buttons, resembling a gamepad. Enables the connection of the nRF24L01 radio module, Nokia 5110 display, Bluetooth module, I2C devices and Arduino kit. modKeyPad

The X-NUCLEO-53L0A1 expansion board features the VL53L0X ranging and gesture detection sensor, based on ST’s FlightSense™, Time-of-Flight technology. It is an evaluation board that provides an introduction to the ranging and gesture detection capabilities of the VL53L0X module