- Out-of-Stock
AVT2994 C
ID: 193089
UNIVERSAL UNIVERSAL PROGRAMMER - SET ASSEMBLED
UNIVERSAL UNIVERSAL PROGRAMMER - SET ASSEMBLED
Producer: AVT
Descriptions of ISP programmers for AVR microcontrollers can be found on the Internet very much. However, the vast majority of them do not work with the USB port. Few supporters of this standard are designed based on the FT232 converter. This is the layout presented. It was created for the electronics using laptops - the standard is that there is no LPT connector, through which earlier versions of programmers were supported.
The device is especially recommended for all programming AVR microcontrollers
Selected parameters:
- support for AVR, MSP430 and ARM microcontrollers
- the possibility of cooperating with 5V and 3.3V powered systems
- LED diodes indicating the programmer status
- built-in USB connector
- power supply - 5Vdc (from USB port)
- system assembled and running
- Detailed description in EdW12 / 11
Download
193089
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
Lithium Polymer rechargeable cell with a Protection circuit. Compatible with ODROID-C0
Retired
No product available!
MYIR MYC-JA5D44 is a single-board computer in the form of a card with SO-DIMM 200-pin connector. The SAMA5D44 processor from Atmel, based on Cortex-A5 cores, has been equipped. It can work with a maximum frequency of 600 MHz. It has 512 MB of DDR2 SDRAM, 512 MB of NAND Flash memory. GPIO ports, interfaces have been derived on the SO-DIMM 200-pin connector.
Retired
No product available!
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
Retired
No product available!
UART GPS Module, NEO-7M-C onboard, straight/vertical pinheader
Retired
No product available!
The Arduino UNO WiFi board is based on the ATmega328 and it has an integrated ESP8266 WiFi Module. If you are starting out with Arduino, or starting with IoT, this is the board to get. A000133
Retired
No product available!
Printed circuit board with programmed layout for a dual-function acoustic switch. AVT3144 A +
Retired
No product available!
Programmed layout for a dual-function acoustic switch. AVT3144 UK
Retired
No product available!
A set for self-assembly of a dual-function sound switch. AVT3144 B
Retired
No product available!
Printed circuit board and programmed clock system with a 20mm display set by means of GPS. AVT5522 / 1 A +
Retired
No product available!
AVT kit for self-assembly of an accurate clock with a 20mm display set by means of GPS. AVT5522 / 1 B
Retired
No product available!
Assembled, accurate clock with 20mm display set by means of GPS. AVT5522 / 1 C
Retired
No product available!
Printed circuit board and programmed clock system with a 55mm display set by means of GPS. AVT5522 / 2 A +
Retired
No product available!
AVT set for self-assembly of the clock with a 55mm display set by means of GPS. AVT552 / 2 B
Retired
No product available!
Assembled clock with 55mm display set by means of GPS. AVT5522 / 2 C
Retired
No product available!
A set of PCB boards and a programmed layout for building a simple led clock. AVT3132 A +
Retired
No product available!
AVT kit for self-assembly of a simple LED clock with a blue display. AVT3132 B
Retired
No product available!
UNIVERSAL UNIVERSAL PROGRAMMER - SET ASSEMBLED