- Out-of-Stock
OIP350B - Isolated fibre optic probe for Micsig oscilloscopes
ID: 1184403
Insulated fibre-optic probe with a measurement range of up to 2500 V. Operates up to 350 MHz and can be connected to an oscilloscope via a BNC connector. Battery-powered. Micsig OIP350B
Description
Isolated fibre optic probe with a measurement range of up to 1250 V. It uses a standard BNC interface and can be connected to an oscilloscope or multimeter. It operates in the frequency band up to 350 MHz. The probe can operate with manual or automatic adjustment and is battery powered. It uses SigOFIT optical isolation technology, so it offers high accuracy and perfectly suppresses oscillations caused by high-frequency common noise. It will find applications in industry, automotive electronics, power supplies and inverters. Dedicated to Micsig brand devices.
Features
- Bandwidth: 350 MHz
- Rise time: 1 ns
- Effective accuracy for 250 MHz bandwidth
- Output voltage: ±1,25V
- Measuring ranges:
- 1X: ±1.25V
- 10X: ±12,5V
- 20X: ±25V
- 500X: ±625V
- 1000X: ±1250V
- Noise: <1.41mVrms
- Signal delay: ＜15.42 ns
- DC gain accuracy: 1%
- Common mode voltage range: 60kVpk
- Power supply: battery powered (DC 5 V charging, USB type C)
- Cable length: 2 m
1184403
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Probe for measuring direct and alternating current up to 100 A. It works in the 2,5 MHz band, it can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP2100B
zł2,143.69
Delivery date unknown
No product available!
A portable oscilloscope for automotive applications with an 8-inch LCD display and a touch screen. It has four channels and has good measurement parameters: 100 MHz bandwidth, 1 GSa/s sampling rate and 70 Mpts memory buffer. Micsig SATO1004 Plus
zł3,756.17
24h
Available quantity: 1
Available
Micsig DP series differential probe based on advanced SigOFIT technology. It offers a frequency band of 100 MHz and the ability to measure voltage up to 700 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig DP700
zł1,195.19
Delivery date unknown
No product available!
Other products in the same category (16)
NanoPi NEO is a miniature board with the all-in-one SoC Allwinner H3 chip (ARM Cortex-A7) with built-in Ethernet communication. Works with Ubuntu MATE, Debian, etc. It can be powered by the microUSB port. The board also contains a USB port, a serial port and a 36-pin GPIO connector
Retired
No product available!
HK HobbyKing HK6S 2.4Ghz FHSS 6Ch Tx & Rx (White) (Mode 2) (47080)
Retired
No product available!
Premium Jumper Wire 10-Pack F-F 12" Red
Retired
No product available!
No product available!
Mobile battery with a capacity of 20000 mAh for charging portable electronic devices, powered by 5V. The power bank is charged via the USB port . PB15 20000 mAh white
Retired
No product available!
No product available!
No product available!
WiFi 802.11 b / g / n module with ESP8266 system, 5 leads are available with 2 mm pitch with the possibility of soldering of gold pins, power lines, reset line and UART interface have been led to the connector. 3.3V power supply
Retired
No product available!
The AM receiver of the DCF77 signal with the MAS6180 system, allows to receive the frames of the synchronization signal from the time standard, using the carrier frequency of 77.5kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna. modDCF77
Retired
No product available!
HK HK-732MG Coreless Digital MG/BB Servo 28g / 3.5kg / 0.07s (23220)
Retired
No product available!
Alphanumeric display OLED 16 characters x 2 lines, with built-in controller WS0010, communicating via 6800 interface, optionally 8080 or SPI. Winstar WEH001602AR
Retired
No product available!
Evaluation board for dipARM modules with STR912 microcontrollers [ARM966E-S core]
Delivery date unknown
No product available!
No product available!
ROSA3D filament made of high-quality ASA polymer. 0.7 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D ASA Silver
Retired
No product available!
BleBox BleBoxProbe is a precise, waterproof digital probe, ideal for temperature control in various conditions, compatible with BleBox devices
Retired
No product available!
Assembled amplified power regulator of 230 VAC receivers. AVT1860 C
Retired
No product available!
Insulated fibre-optic probe with a measurement range of up to 2500 V. Operates up to 350 MHz and can be connected to an oscilloscope via a BNC connector. Battery-powered. Micsig OIP350B