.png)
- Out-of-Stock
Qwiic Fuel Gauge module with battery performance monitor MAX17048
ID: 1186212
5906623418718
LiPo battery monitor module based on the MAX17048 chip. Allows the voltage and state of charge of the battery to be measured. SparkFun SPX-17715
Description
LiPo battery monitor module based on the MAX17048 chip to measure the voltage and state of charge of the cell. There are two JST PH2.0 connectors on the board for battery connection and power output. The module can work with systems with an operating voltage of 3.3 V or 5 V, and communication is via the I2C interface (Qwiic connector).
Features
- Performance measurement of LiPo batteries
- Indicates cell voltage and charge level
- Interface: I2C
- Voltage: 3.3 V or 5 V
- Qwiic connector
- Dimensions: 32 x 32 mm
1186212
Manufacturer
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
Responsible person
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
You might also like
SparkFun Qwiic kit. Contains 10 wires of different lengths and tips. It allows you to connect Qwiic modules to a programming platform or to a prototype board. SparkFun KIT-15081
zł57.34
24h
Available quantity: 2
Available
Data logger programmed to automatically record data from GPS and Qwiic series sensors. It has a built-in ESP32-WROOM-32E module and IMU sensors ISM330DHCX (accelerometer and gyroscope) and MMC5983MA (magnetometer). SparkFun DEV-20594
zł389.98
24h
Available quantity: 1
Available
Other products in the same category (16)
No product available!
Banana Pi M2+ is another ARM SoC powered development board that offers great computing performance in an ultra portable form factor. It is a 65mm square with Allwinner H3 Quad-core A7 SoC and 1GB DDR3 RAM
Retired
No product available!
Self-assembly DIY enclosure for Banana Pi M2+, transparent
Retired
No product available!
LSF0204PWR, 4-Bit Bidirectional Multi-Voltage Level Translator for Open-Drain & Push- Pull, TSSOP14
Retired
No product available!
Lithium Polymer rechargeable cell with a Protection circuit. Compatible with ODROID-C0
Retired
No product available!
MYIR MYC-JA5D44 is a single-board computer in the form of a card with SO-DIMM 200-pin connector. The SAMA5D44 processor from Atmel, based on Cortex-A5 cores, has been equipped. It can work with a maximum frequency of 600 MHz. It has 512 MB of DDR2 SDRAM, 512 MB of NAND Flash memory. GPIO ports, interfaces have been derived on the SO-DIMM 200-pin connector.
Retired
No product available!
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
Retired
No product available!
This is the Green Adafruit 0.56" 4-Digit 7-Segment Display w/ FeatherWing Combo Pack! We also have these combo packs in Blue, Red, White, and Yellow! Adafruit 3107
Retired
No product available!
UART GPS Module, NEO-7M-C onboard, straight/vertical pinheader
Retired
No product available!
The Arduino UNO WiFi board is based on the ATmega328 and it has an integrated ESP8266 WiFi Module. If you are starting out with Arduino, or starting with IoT, this is the board to get. A000133
Retired
No product available!
Printed circuit board with programmed layout for a dual-function acoustic switch. AVT3144 A +
Retired
No product available!
Programmed layout for a dual-function acoustic switch. AVT3144 UK
Retired
No product available!
A set for self-assembly of a dual-function sound switch. AVT3144 B
Retired
No product available!
Ideal for environmental sensing and data logging and perfect for build a weather stations or humidor control system; built-in 4.7KΩ pullup resistors for I2C communications. SEN-13763
Retired
No product available!
Printed circuit board and programmed clock system with a 20mm display set by means of GPS. AVT5522 / 1 A +
Retired
No product available!
AVT kit for self-assembly of an accurate clock with a 20mm display set by means of GPS. AVT5522 / 1 B
Retired
No product available!
LiPo battery monitor module based on the MAX17048 chip. Allows the voltage and state of charge of the battery to be measured. SparkFun SPX-17715