AVT2948 A +

In case we want to install a new chandelier, it may turn out that the electrical installation is insufficient. As a standard, two power cords used in many homes make it impossible to simply connect a chandelier with two sections. It is obvious that in this situation, hardly any tenant will decide to break the ceiling and position the additional wire. The solution is simple - just use the presented module. It allows full control of the two-section chandelier through a standard two-wire installation. Appropriate lighting conditions are caused by a traditional one-section wall switch.

The device is especially recommended in home lighting installations

Selected parameters:

• control of two lighting sections through a two-wire supply line
• switching on and extinguishing a chandelier with a single switch
• selection of lighting mode: first section, second section, two sections at the same time
• remembering the last setpoint
• the system is mounted directly to the chandelier's luminaire
• executive elements - triacs
• power supply - 230Vac
• a printed circuit board, programmed layout and documentation in the set
  
  A detailed description in
  EP 8/10