- Out-of-Stock
LPC1768-Xplorer
ID: 196794
Evaluation board with LPC1768, USB, Ethernet, NGX Technologies, RoHS
LPC1768-Xplorer
Evaluation board with LPC1768 MCU, USB, Ethernet, NGX Technologies, RoHS
LPC1768-Xplorer is a CORTEX-M3 based stamp board for NGX’s mbed-Xpresso Baseboard. The LPC1768 microcontroller has 512KB of internal flash and 64KB RAM. Ethernet MAC, USB Device/Host/OTG interface, 8-channel general purpose DMA controller, 4 UARTs, 2 CAN channels, 2 SSP controllers, SPI interface, 3 I2C-bus interfaces, 2-input plus 2-output I2S-bus interface, 8-channel 12-bit ADC, 10-bit DAC, motor control PWM, Quadrature Encoder interface, 4 general purpose timers, 6-output general purpose PWM, ultra-low power Real-Time Clock (RTC) with separate battery supply, and up to 70 general purpose I/O pins
Features:
- Dimensions: 27x101 mm2
- On-board Test Led
- 12MHz crystal
- 25MHz crystal for Ethernet
- 32kHz RTC crystal
- On board USB Host / Device support
- On board Ethernet Transceiver
- On board dual port USB power switch and Over-current protection
- On board Micro-SD card holder
- On board 10 pin SWD
- On board reset switch
Contents:
- LPC1768-Xplorer evaluation board
- Micro USB Cable
196794
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
Waveshare WIFI232 Eval Kit is an evaluation board WIFI501 with WIFI232-B module. The board has a USB - UART converter, a reload button, an RJ45 ethernet interface connector and an RS485 interface connector. Waveshare WIFI232 Eval Kit
Retired
No product available!
Waveshare Mix Board, 4 in 1 adapter plate, includes temperature sensor, infrared receiver, joystick and buzzer
Retired
No product available!
Alphanumeric display OLED 4x20, with built-in controller WS0010, communicating via 6800 interface, optionally 8080 or SPI. Winstar WEH002004AB
Retired
No product available!
Alphanumeric display OLED 4x20, with built-in controller WS0010, communicating via 6800 interface, optionally 8080 or SPI. Winstar WEH002004AW
Retired
No product available!
Printed circuit board to secure - a simple car lock. AVT3187 A
Retired
No product available!
AVT kit for self-assembly protection - a simple car lock. AVT3187 B
Retired
No product available!
Printed circuit board for vapor extraction controller. AVT3215 A
Retired
No product available!
AVT kit for self-assembly of a vapor extraction controller. AVT3215 A
Retired
No product available!
Assembled fume extraction controller. AVT3215 C
Retired
No product available!
No product available!
No product available!
NanoPi NEO Core Allwinner H3 Quad-Core 1,2Ghz + 256MB RAM
Retired
No product available!
NanoPi NEO Core2, Allwinner H5 Quad-Core 1.5Ghz + 1GB RAM + 8GB eMMC, without soldered GPIO pins
Retired
No product available!
NanoPi NEO Core is a small PCB equipped with the SoC Allwinner H3 chip and 512MB RAM. The GPIO port has been moved, among others Ethernet, USB, SPI, UART, I2C, I2S interface. The board can be powered from the Micro USB connector. FriendlyELEC NanoPi NEO Core
Retired
No product available!
NanoPi NEO Plus 2 single board computer (SoC) with Allwinner H5 processor Quad-Core 1GHz + 1GB RAM + 8GB eMMC, SoC (ARM Cortex A-53)
Retired
No product available!
A small minicomputer with the SoC Allwinner H5 quad-core system (ARM Cortex-A53). The system has a built-in 16-core Mali450 graphics coprocessor. The computer is equipped with 512 MB DDR3 RAM. There are images of UbuntuCore and Armbian systems available for the computer. NanoPi NEO2
Retired
No product available!
Evaluation board with LPC1768, USB, Ethernet, NGX Technologies, RoHS