- Out-of-Stock
The RF in RFID
ID: 205567
Daniel Dobkin
Ten years ago when RFID technology came into the scene, the power and integrated circuits were very basic. However, in the last three years there has been a lot of problems. For example. RFID technology can be used for monitoring patients' health in hospital beds.
This book explains how UHF tags and readers communicate wirelessly. It gives you an understanding of RFID technology and how it can increase RFID technology. Avoiding heavy math but giving breadth of detail. New to this edition: Examples of near-metal antenna techniques. Discussion of the wakeup challenge for battery-assisted tags, with a BAT architecture example. Latest development of protocols: EPC Gen 1.2.0. Update 18000-6 discussion with battery-assisted tags, sensor tags, Manchester tags and wakeup provisions. Frequency Identification (RFID). and depth of coverage. New edition includes latest developments in chip technology, antennas and protocols.
This book explains how UHF tags and readers communicate wirelessly. It gives you an understanding of RFID technology and how it can increase RFID technology. Avoiding heavy math but giving breadth of detail. New to this edition: Examples of near-metal antenna techniques. Discussion of the wakeup challenge for battery-assisted tags, with a BAT architecture example. Latest development of protocols: EPC Gen 1.2.0. Update 18000-6 discussion with battery-assisted tags, sensor tags, Manchester tags and wakeup provisions. Frequency Identification (RFID). and depth of coverage. New edition includes latest developments in chip technology, antennas and protocols.
205567
Other products in the same category (16)
The eMMC 5.1 flash memory module for Hardkernel Odroid C2 computers. 32GB capacity, Android operating system installed. The set includes a microSD adapter. Hardkernel
Retired
No product available!
Development kit with STM32F107VCT6 microcontroller
Delivery date unknown
No product available!
Side panel with I/O elements for Totem Mini Lab and Totem Micro Lab sets. There are buttons, potentiometers, LED diodes and a relay on the board. Totem TE-SP01-B
Retired
No product available!
HK Turnigy nano-tech 1800mah 3S 65~130C Lipo Pack (19120)
Retired
No product available!
No product available!
Universal ISP programmer for CPLD and FPGA (Altera, Xilinx) and AVR and AT89Sxxxx microcontrollers
Delivery date unknown
No product available!
0.1" (2.54mm) Crimp Connector Housing: 1x6-Pin 10-Pack
Retired
No product available!
MINIATURE, STEREOPHONE POWER AMPLIFIER WITH 2X3W POWER - SYSTEM HOLDED AND STARTED
Retired
No product available!
AVT kit for self-assembly of an android driver with FT311D. AVT5575 B
Retired
No product available!
Low voltage alarm for LiPo 2s ~ 3s packets (HK22749)
Retired
No product available!
The thickness gauge GL-1 Fe enables the measurement of varnished steel and galvanized steel sheets. The device has a memory of 100 measurements. Calibration plates included. The display is backlit
Retired
No product available!
A 150mm 2-wire cable terminated terminated with a plug and socket JST XH2.54.. 22AWG cable diameter.
Retired
No product available!
Audio recorder module that allows for multiple recording and playback of sounds up to 6 seconds long
Retired
No product available!
No product available!
This gearmotor is a powerful 12V brushed DC motor with a 30:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 64 counts per revolution of the motor shaft, which corresponds to 1920 counts per revolution of the gearbox’s output shaft. These units have a 0.61"-long, 6 mm-diameter D-shaped output shaft. This gearmotor is also available without an encoder.
Retired
No product available!
No product available!
Daniel Dobkin