- Out-of-Stock
AVT5400 A +
ID: 208695
DMX DIMMER & RELAY - PRINTED PLATE AND PROGRAMMED SYSTEM
DMX DIMMER & RELAY - PRINTED PLATE AND PROGRAMMED SYSTEM
Producer: AVT
The DMX (Digital MultipleXed Protocol) system enables the operation of 512 devices, such as: heaters, curtains, movable elements of the scene. The transmission uses one pair of wires. It is widely used in cinemas, theaters and operas.
Recommendations: the device will be useful for people involved in the set design and technical arrangement.
Selected parameters:
- DMX-512 signal reception
- control of the relay and dimmer
- con gured functions in the absence of transmission: turning off the receiver, remembering the last state
- receiver address is updated on-line
- increased resistance to transmission errors
- power consumption 4 W
- maximum load current of relay contacts 16 A
- the maximum triac current of the regulator:
- without heat sink: 2 A (460W)
- with heatsink: 4 A (920 W)
- controller load, e.g. 230 VAC bulb with power up to 900 W (using a heat sink)
The set includes a printed circuit board, programmed layout and documentation.
A detailed description in EP6 / 13 or 
208695
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
Low cost programmer for STM32 and STM8 microcontrollers fully compatible
with the ST-Link V2
Retired
No product available!
No product available!
256kB Flash, 16kB Flash, 64 kB RAM, USB, 2xI2C, 4xUART, 2xSPI, 12-bit ADC
Retired
No product available!
Michel Chipot
Delivery date unknown
No product available!
Stereo tube preamplifier based on 6J3 tubes. Designed for use with active speakers or an additional amplifier and passive speakers
Retired
No product available!
ArduCam camera module with autofocus designed for Raspberry Pi. It was equipped with a matrix (Sony IMX219) with 8 MPix resolution and an integrated IR filter. To connect the camera with Raspberry Pi is implemented using a CSI connector. Autofocus allows sharpening in the range from 4 cm to infinity. ArduCAM B0122
Retired
No product available!
No product available!
No product available!
No product available!
USB Type-C PD power supply with a power of 27 W. It is dedicated to, among others: for Raspberry Pi 5 minicomputers. It has a European plug and supports USB Power Delivery 5.1V/5A, 9V/3A, 12V/2.25A, 15V/1.8A. Waveshare PSU-27W-USB-C-EU
Retired
No product available!
No product available!
Vector network analyzer with two ports. It can perform measurements at frequencies from 500 kHz to 4 GHz. Connected to a computer via USB. Pocket VNA
Retired
No product available!
The DE0-Nano-SoC Development Kit presents a robust hardware design platform built around the Altera System-on-Chip (SoC) FPGA, which combines the latest dual-core Cortex-A9 embedded cores with industry-leading programmable logic for ultimate design flexibility
Retired
No product available!
No product available!
No product available!
No product available!
DMX DIMMER & RELAY - PRINTED PLATE AND PROGRAMMED SYSTEM