- Out-of-Stock
Turnigy 9XR Safety Protected 11.1v (3s) 2200mAh 1.5C Transmitter Pack (31315)
This battery is designed exclusively for the New Turnigy 9XR radio system.
The pack has both over charge / discharge protection and over current protection built right into the battery, this adds significant safety to the 9xr system.
Spec:
Capacity: 2200mAh
Voltage: 11.1v
Constant discharge: 1.5C (3.3amps)
Max charge rate: 1C (2.2amps)
Standard rate: 0.5c (1.1amps)
Charge cut off: 12.6v
Discharge cut off: 9.0v
Over current cut: 5 amps
Burst discharge: N/A
Weight: 139g
Size: 100x33x19mm
Plugs: JST & JST-XH
Note: This battery is only to be used in Radio Transmitters
PRODUCT ID: 9171000183
Download
| Customer files | ||
| 9xr batt with JST ext plug | 1984kb | |
Data sheet
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
SanDisk Ultra microSDHC card with 16 GB capacity, maximum read speed up to 98 MB / s, SD adapter included. SanDisk SDSQUAR-016G-GN6MA
No product available!
High quality stable and low noise power supply for Odroid XU4 and HC1. DC 5.5x2.1 plug
No product available!
No product available!
Arducam Nano RPI Module is a minicomputer equipped with Broadcom BCM2835 processor and VideoCore IV GPU. The module has two CSI connectors for connecting cameras, video output (PAL), SPI, I2C, UART, and GPIO. ArduCam B0101
No product available!
3.5 "TFT display with touch panel, transparent housing and 16 GB SD card for Raspberry Pi 3. ArduCAM U470302
No product available!
Display with a touch screen (resistive panel) with a diagonal of 3.5 inches and a resolution of 480 x 320 pixels. Uses the SPI interface. Intended for use with the Raspberry Pi Zero / B + / 2/3 minicomputer. ArduCAM U470301
No product available!
A set of basic electronic components complete with contact plate, connecting cables and Mega2560 R3. It is ideal for beginner electronics who also know Arduino. ArduCAM KB0003
No product available!
A set of basic electronic components complete with contact plate, connecting cables and board compatible with Arduino UNO R3. It is ideal for beginner electronics who also know Arduino. Uctronics KB0002
No product available!
A set of basic electronic components complete with contact plate, connecting cables and Arduino UNO R3. It is ideal for beginner electronics who also know Arduino. ArduCAM KB0001
No product available!
Orange filament 1.75 mm 0.85 kg Easy PLA by Fiberlogy
No product available!
No product available!
No product available!
12 pin GPIO ribbon cable (200mm) for Odroid XU4 and Odroid XU4Q
No product available!
7 pin GPIO ribbon cable (20 cm) for Odroid C4
No product available!
No product available!
3-wire cable with JST-ZH plug, 30 cm, 3x1 JST, 1.5 mm pitch
No product available!
HK Turnigy 9XR Safety Protected 11.1v (3s) 2200mAh 1.5C Transmitter Pack (31315)