- Out-of-Stock
Nosal Zbigniew, Baranowski Jerzy
Part I of the three-volume manual discusses classical circuits, systems with MOSFETs and MOS integrated circuits. Classification of models, load method for their models, models of diodes and transistors, configurations of elements, types and work of amplifiers and stabilizers are presented.
The book is intended for students of electronics faculties of technical universities, especially in the field of hardware and apparatus specialties.
Table of Contents
List of important markings
1. Introduction
2. Models of basic semiconductor devices
3. Transistor supply systems
4. Basic amplifier circuits
5. Feedback connection
6. Broadband and impulse amplifiers
7. Operational amplifiers
8. Selective amplifiers
9. Power amplifiers
10.Stabilizers with continuous operation
Appendix 1.
Matrix description of linear systems
Appendix 2.
Frequency characteristics of concentrated systems
Index
MOD-21.Z - push button module with bistable operation. The sensor operates based on the AT42QT1012 system.
No product available!
The Raspberry Pi GPIO connector adapter allows you to output signals from Raspberry Pi to the contact plate. Two LEDs indicate +3.3V and +5V power supply
No product available!
No product available!
MOD-25.Z - touch sensitive button module with monostable function. The sensor operates based on the AT42QT1011 system.
No product available!
No product available!
No product available!
The module enables connection of two devices with I2C interface working with different voltage levels. MOD-28.Z
No product available!
It is used to monitor the temperature measurement and other parameters. The expansion module has an I2C / 1-Wire converter (DS2482) through which DS18B20 temperature sensors can be connected using two or three wires. MOD-29.Z
No product available!
Power module with IRFR4105Z transistor (MOD-30.Z), maximum current 2A, 5V power supply or 5V - 12V range (selection by jumper)
No product available!
The module with the DS18B20 sensor is used to measure the temperature in the range from -55° C to + 125° C, with an accuracy of +/- 0.5° C in the range from -10° C to + 85° C. The module communicates via the 1-Wire interface, thanks to which it can be connected using 2 or 3 wires - depending on the configuration. Temperature measurement can be performed with an accuracy of 9 to 12 bits. MOD-31.Z
No product available!
Universal module with LM358 operational amplifier. Depending on the additional elements installed, the amplifier can be freely configured, eg as a reversing, non-inverting amplifier, voltage follower or an integrating amplifier. MOD-32.Z
No product available!
No product available!
The modally controlled modulation module MOD-34 / BZ allows wireless load control with a current consumption of up to 10A via a relay. Includes wireless module nRF24l01.
No product available!
No product available!
No product available!
No product available!
Nosal Zbigniew, Baranowski Jerzy