- Out-of-Stock
Practical electronics 10/2017
ID: 566345
Practical Electronics 10/2017
In the issue
Do not miss
- New components
- Cocktail of Noodles
- Prediction
projects
- Multizasilacz
- Solar battery charger LiFePo4
- Magic Matrix. Magically colored clock, alarm clock with remote control, thermometer, Wi-Fi, SMS, Android smartwatch (1)
- Modular listening receiver for the 80 m and 40 m "Dosia" bands (2)
- Universal time relay with SKEDD connector
Soft projects
- Braille alphabet printer
Miniprojekty
- Relay supplied with a wide voltage range
- A miniature, stereo power amplifier
Readers' projects
- Three-phase TRMS voltmeter
Equipment
- Voltcraft CT-20TDR cable tester
Builder notebook
- Measuring laboratory electronics based on Raspberry Pi 3 and Analog Discovery 2
components
- STM8S001J3 (1). Introduction. The first STM8 microcontroller in an 8-pin housing
Automation and mechatronics
- Entry gate controller for LOGO! 8. Project with a hardware environmental simulator
- 3D printing for electronics (2)
KAP
- Get to know the STM8 microcontrollers thanks to the STM8SVLDISCOVERY evaluation board
presentations
- Dataforth MAQ20 - modular control and measurement system
courses
- Systems for the Internet of Things (10). CC1350 SensorTag set
- Renesas Synergy - serial interfaces (3)
- How to use Xilinx Zynq-7000 SoC systems with Linux - simple examples (2)
- LoRa in practice (1)
- Programming STM32F4 (10)
Subscription
- Kramik and the market
- Hits of the next issue
566345
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
3D printer with automatic table levelling and print resume function. Equipped with a dual Z-axis and a filament sensor. It offers a large workspace of 300 x 300 x 400 mm and uses a Direct Drive extruder. Artillery Sidewinder X2
Retired
No product available!
Bodhilabs VPack5.0V 2-AA Battery Holder w/ 5V Regulator
Retired
No product available!
Camera with a USB interface with a resolution of 16 MP. Equipped with a Sony CMOS IMX298 sensor and an M12 lens with a viewing angle of 70°. ArduCAM B0246
Retired
No product available!
No product available!
No product available!
A small Li-Pol battery with a nominal voltage of 3.7 V and a capacity of 1350 mAh. Leaded wires, dimensions: 5 x 37 x 59 mm. Akyga LP503759
Retired
No product available!
4-digit 7-segment display with MAX7219 driver chip. Adafruit 1268
Retired
No product available!
No product available!
No product available!
Set with six microphones designed for audio applications for Raspberry Pi minicomputers. It consists of a board with microphones and a module with audio circuits. Seeed Studio 107990055
Retired
No product available!
No product available!
No product available!
Set with orange EL Wire. The set includes an inverter, a 1 to 5 branching and 5 EL Wire in orange color with a length of 1m.
Retired
No product available!
NanoPI NEO is a single-board chip from FriendlyELEC with a RAM of 256 MB, successfully competing with the systems created by the giant in this field Raspberry Pi. It is 25% smaller and cheaper than the Raspberry Pi Zero board with similar capabilities
Retired
No product available!
No product available!
The special construction of the braid facilitates installation in all conditions. z28423
Retired
No product available!
Practical Electronics 10/2017