Category: STARTER KITS, PROGRAMMERS, MODULES

STM32 Nucleo-64 development board with STM32F410RBT6 MCU, supports Arduino and ST morpho connectivity

Module with an 11-channel AS7341 sensor that allows the detection of light in various wavelength ranges (color detection). It is equipped with a Gravity connector and communicates via the I2C interface. DFRobot SEN0364

Development board with Bluetooth 5.2 BGM220P module from Silicon Labs. It is equipped with a mikroBUS socket and a Qwiic connector and a 20-pin connector with peripherals such as I2C, SPI, UART and GPIO. SparkFun DEV-17588

Plate from the Adafruit Feather series equipped with an ATmega32u4 microcontroller and a small prototype surface (5x7). The chip contains 32KB flash memory, 2KB RAM memory and built-in USB support. The plate is compatible with Arduino. Adafruit 2771

Analog pH Meter Pro (SEN0169)

Module with the LIS3DHTR 3-axis accelerometer. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 114020121

Module with a 3-axis magnetic field sensor LIS3MDL. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4479

MEMS SPU0414HR5H-SB analog microphone module. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020852

Shield for STM32 series Nucleo, XNucleo and Arduino series for communication via RS485 and CAN interfaces (CAN is only available for Nucleo and XNucleo plates). Shield is based on MAX3485 and SN65HVD230 systems

Module for recording sounds, which can store recordings up to 20 seconds. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 107020007

Module with four gas sensors that allow the detection of CO, NO2, alcohol and volatile organic compounds (VOC). The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020820

STM32 Nucleo development board for STM32 L0 series - with STM32L053R8 MCU, 64KB flash memory, STM, RoHS

Module with 2-channel driver for DC motors L298P. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 105020093

Gravity: Heart Rate Monitor Sensor is a sensor used to measure heart activity. Adapted for easy use with Arduino. SparkFun SEN0213

Development kit with QN9090 (T) Bluetooth LE 5.0 module complete with base board and expansion board. It is powered by the USB connector or from an external source via the DC connector. NXP QN9090-DK006

Analogue temperature and humidity sensor module based on SHT30 sensor. It is characterized by high reliability and stability with low energy consumption. It is compatible with 3.3V and 5V controllers, such as Arduino, micro:bit, ESP32. DFRobot DFR0588

A standard device for communication with the ESP32 device under test (DUT) during production testing. Espressif ESP-BAT32

STEVAL-IHI002V1 is a compact demonstration board based on the STMPE1208S touch controller. It enables testing and implementation of capacitive interfaces in applications with the I²C bus, replacing traditional buttons with capacitive touch sensors. Ideal for integration in modern control panels.

Evaluation board with STM32F407 microcontrollerStarter kit equipped with a microcontroller STM32F407IGH6 (1 MB Flash, Cortex-M4), with a built-in programmer-debugger ST-Link/V2, equipped with a 3.2" TFT LCD display and a full set of connectors.