Category: STARTER KITS, PROGRAMMERS, MODULES

Module with a 3-axis analog MMA7361 accelerometer. There are 3 Gravity connectors on the board (for each axis). The operating range of the sensor can be configured using a DIP switch. DFRobot DFR0143

The servo controller module is an extension for the micro:bit. Allows you to control 16 PWM channels. Waveshare 15072

Contrast sensor module. It has two integrated operating modes: analog and digital. It has the ability to set the digital mode for color detection. DFRobot SEN0147

Flash Programmer for ARM and Cortex cores, Segger

Module with green LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0031-G

Module with red LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0031-R

Soil moisture sensor with I2C interface. The probe has two pointed tabs, making it easy to insert into the ground. The sensor is supplied with the voltage of 3.3 V or 5 V. SparkFun SEN-17731

Module with gas sensor SGP30. It allows you to measure the content of total volatile organic compounds (TVOC), carbon dioxide equivalent (eCO2), ethanol and H2 in the air. M5Stack U088

Module with an analog sensor of carbon monoxide and combustible gases (methane, propane) MQ9. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0134

The STEVAL-FKI433V2 evaluation board is based on the S2-LP sub-1GHz ultra-low power low data-rate transceiver suitable for ISM bands and wireless M-Bus. The NUCLEO-L053R8 motherboard is equipped with an STM32L0 low power microcontroller to control the S2-LP

Ammeter module designed for M5Stack sets. It can measure direct current in the range from 0 to 4 A with a resolution of approx. 0.15 mA. M5Stack U086

A set for building a walking robot. The chassis is equipped with four servos, a controller and an STM32F030 microcontroller. M5Stack U086

Extension board designed for MicroMod processor modules. All the pins are led out to connectors with a pitch of 2.54 mm. SparkFun DEV-16885

M5Stack U138 is an expansion board designed to work with the M5Stack platform, enabling easy prototyping of IoT solutions and educational projects. It offers additional connectors such as UART, GPIO, I2C and SPI, allowing integration with various sensors and modules, making it an ideal tool for engineers, developers and hobbyists.

Extension board designed for MicroMod main modules. Equipped with digital microphones, accelerometer and camera connector. A great tool for machine learning projects. SparkFun DEV-16400

MicroMod main module equipped with Bluetooth 5.0 Sparkfun Artemis. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun DEV-16401

MicroMod main module with ESP32 chip. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun WRL-16781

MicroMod main module with SAMD51 microcontroller. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun DEV-16791

The STEVAL-FKI868V2 evaluation board is based on the S2-LP sub-1GHz ultra-low power low data-rate transceiver suitable for ISM bands and wireless M-Bus. The NUCLEO-L053R8 motherboard is equipped with an STM32L0 low power microcontroller to control the S2-LP

MYD-SAM9X35 Development Board, MYIR