The M5Stack AMeter Unit is an ammeter module designed for the M5Stack sets. It can measure direct current in the range from 0 to 4 A with a resolution of approx. 0.15 mA. It is based on a 16-bit ADC converter, which communicates with the evaluation kit via the I2C interface (Grove connector). The module has a built-in isolated power circuit, and the I2C interface is also galvanically isolated through the CA-IS3020S low-power isolator, which prevents noise and surges from penetrating the data bus. The ammeter will be used in projects where accurate current measurement is required. Full documentation is available on the product page.

Manufacturer
Responsible person
M5Stack series development kit equipped with WiFi and Bluetooth ESP32 module. It will work in IoT-related projects, as a STEM educational module or in Smart Home devices. M5Stack K010
No product available!
3-port Hub with Grove connectors for M5Stack sets. It allows you to connect several devices with Grove connectors to the evaluation kit. M5Stack HUB Unit
Voltmeter module for M5Stack sets. It can measure DC voltage in the range from 0 to 36 V with an accuracy of approx. 0.5 mV. M5Stack U087
ATOM Lite development kit complete with microSD card reader up to 16 GB. M5Stack K044
The universal DIY prototype module from the M5stack series with M-BUS connector. M5Stack M032
Lipo battery with a capacity of 750 mAh for the M5Stack sets. Modules can be connected in parallel and stacked. M5Stack M002
A 16-channel servo driver module designed to work with the M5Stack sets. It is powered with the voltage from 6 to 12 V. M5Stack M014-B
No product available!
Prototype kit for use in industry. It includes a prototype board with an M-BUS connector, TTL-RS485 converter, connectors and a DIN rail. M5Stack Base26
MEMS SPM1423 digital microphone module with PDM modulation. It communicates via the I2S interface. M5Stack U089
Module with gas sensor SGP30. It allows you to measure the content of total volatile organic compounds (TVOC), carbon dioxide equivalent (eCO2), ethanol and H2 in the air. M5Stack U088
Module with three Hall sensors A3144E, which react to the failure of the magnet. It is powered with 5 V and has a digital output on the Grove connector. M5Stack U084
Module with receiver designed for communication by means of a laser beam transmitted in the air. M5Stack Laser.Rx Unit
Module with a transmitter designed for communication via a laser beam transmitted in the air. M5Stack Laser.Tx Unit
Universal module for prototyping. It has 40 prototype fields with a diameter of 1 mm and a race of 2.54 mm and a Grove connector. M5Stack Mini Proto Unit
Module of a small fan driven by a DC motor. The set includes two propellers with a diameter of 60 mm. M5Stack Fan Unit
Compact module with vibration motor. It consists of a DC motor and an eccentric wheel. M5Stack Vibration Motor Unit
The module with a fingerprint sensor FPC1020A is designed for the M5Stack sets. The sensor has a built-in memory and can store up to 150 fingerprints. M5Stack U008
IO port expander for M5Stack kits. Equipped with 8 IO pins and power pins, it communicates via the I2C interface. M5Stack U011-B
12-bit DAC converter module designed to work with the M5Stack sets. It enables the conversion of digital signals into an analog signal. M5Stack DAC Unit
Ammeter module designed for M5Stack sets. It can measure direct current in the range from 0 to 4 A with a resolution of approx. 0.15 mA. M5Stack U086