M5Stack Laser.Rx Unit - laser receiver module

Kit for building a worm robot. The chassis is equipped with four motors and a controller, 2 RGB diodes and an STM32F030 microcontroller. M5Stack K033

Module with a black and white OLED display 1.3" with a resolution of 128x64 pixels. Designed for M5Stack sets. It communicates via the I2C interface. M5Stack U119

Module with a PIR motion sensor designed for M5Stack modules. It can detect movement up to 5 meters with a detection angle of 100 degrees. M5Stack U004

USB module based on MAX3421E wrap designed for M5Stack sets. It communicates with the evaluation kit via the SPI interface and allows the addition of a Host or USB device function. M5Stack M020

The module with a fingerprint sensor FPC1020A is designed for the M5Stack sets. The sensor has a built-in memory and can store up to 150 fingerprints. M5Stack U008

Module with a transmitter designed for communication via a laser beam transmitted in the air. M5Stack Laser.Tx Unit

Prototyping kit designed for sets from the M5ATOM series. It includes a prototyping board and numerous connectors. M5Stack ATOM HUB DIY Proto

Module with a light sensor (photoresistor) designed for M5Stack sets. An analog output and a digital output have been led out on the Grove connector. M5Stack U021

Module of a small fan driven by a DC motor. The set includes two propellers with a diameter of 60 mm. M5Stack Fan Unit

3-port Hub with Grove connectors for M5Stack sets. It allows you to connect several devices with Grove connectors to the evaluation kit. M5Stack HUB Unit

M5Stack series kit equipped with ESP32 and camera with OV2640 sensor. It has a built-in W5500 chip and can be powered by the RJ45 (PoE) connector. M5Stack U121

The module with a 10 kΩ slide potentiometer and a color LED indicator, designed for the M5Stack sets. M5Stack U123

Lipo battery with a capacity of 750 mAh for the M5Stack sets. Modules can be connected in parallel and stacked. M5Stack M002

The CAN transmitter and receiver module is intended for M5Stack sets. It is based on an isolated CA-IS3050G transceiver system, which can provide differential data reception and transmission. M5Stack U085

The module is equipped with three RGB SK6812 LEDs. It is designed to work with the M5Stack sets. Communicates via a single-wire digital interface. M5Stack U003

The module is equipped with two buttons in red and blue. It communicates via a digital interface and allows you to add simple controls to your M5Stack based project. M5Stack U025