Category: STARTER KITS, PROGRAMMERS, MODULES
Kamami.pl electronics store offers a wide range of starter kits for microcontrollers and programmable devices as well as accessories (programmers, modules, etc.).
Subcategories
-
Atmel SAM
-
Atmel Xplain
-
AVR
-
Banana Pi
-
BeagleBone
-
chipKIT
-
CPLD Xilinx
-
Cubieboard
-
DFRobot FireBeetle
-
Analog electronics
-
Feather
-
Alchitry FPGA
-
Altera FPGA
-
Xilinx FPGAs
-
Freedom (Kinetis)
-
FriendlyELEC
-
Coral
-
HummingBoard
-
Other development kits
-
Intelligent clothes
-
LattePanda
-
LPC (NXP)
-
M5Stack
-
Micro:bit
-
Peripheral modules
-
Nvidia Jetson
-
Odroid
-
ODYSSEY
-
Orange Pi
-
PIC
-
Segger programmers
-
Universal programmers
-
Raisonance
-
Raspberry Pi RP2040
-
RFID
-
RISC-V
-
SBC Embest
-
SBC MYIR
-
SBC UDOO
-
SBC others
-
SoMLabs
-
Sparkfun MicroMod
-
STM32
-
STM32 MP1
-
STM32 Discovery
-
STM32 Nucleo boards
-
STM8
-
Teensy
-
WRTNode
-
Kit with a book
There are 2798 products.
A module with a SoC chip containing four 64-bit ARM Cortex A57 cores and a Pascal graphics chip consisting of 256 cores supporting CUDA technology. NVIDIA Jetson TX2 NX
No product available!
Development board equipped with STM32 series microcontroller (STM32H743IIT6). It is equipped with all the necessary elements for project development, requires an external programmer. Waveshare CoreH743I
No product available!
An expansion board designed for MicroMod main modules. Equipped with the LTE-M / NB-IoT u-blox SARA-R510M8S module. It allows you to monitor devices remotely. SparkFun DEV-17272
No product available!
Sound terminal expansion board based on STA350BW for STM32 Nucleo
No product available!
Digital logic level shifter ideal for users who want to supply logic signals following a 3.3V CMOS standard but have an alternate logic level output that is used for other applications, such as JTAG programming. 410-320
No product available!
A single board computer with a powerful Intel Cherry Trail Z8350 processor, 2GB RAM, 32GB eMMC and a Windows 10 OEM system (key included). It was equipped with a WiFi module and Bluetooth 4.0. DFRobot DFR0418
No product available!
Module with 5-way joystick. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 111020048
No product available!
Module with a GPS receiver based on the MTK3333 system. Dedicated to Feather plates, communicates via the UART interface. Adafruit 3133
No product available!
Module with a UV light sensor VEML6070. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 101020600
No product available!
CoreEP4CE10 is a bootable board with the FPGA EP4CE10F17C8N chip from the Altera Cyclone IV family. Waveshare CoreEP4CE10
No product available!
Module with a 6-axis BMI088 sensor that combines an accelerometer and a gyroscope. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 101020584
No product available!
Module with 8x8 LED matrix in red and HT16K33 LED driver. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 104020089
No product available!
The module with the CY8C4014LQI touch sensor in the form of two buttons and a 5-segment slider. The board is equipped with a Grove connector and communicates via I2C. Seeed Studio 101020552
No product available!
A set of necessary tools needed to perform vehicle diagnostics. It consists of a CAN Bus module, an OBD II connector and the necessary wires. Seeed Studio 114991438
No product available!
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
No product available!
Module with vibration sensor SW-420. The board is equipped with a Grove connector and has a digital output. Seeed Studio 101020586
No product available!
Module with a 9-axis IMU sensor, which combines an accelerometer and a gyroscope (ICM20600 system) and a magnetometer (AK09918 system). The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020585
No product available!
Starter kit with Grove modules designed to work with the Azure Sphere MT3620 development board. Seeed Studio 110060947
No product available!
MYIR MYC-JA5D44 is a single-board computer in the form of a card with SO-DIMM 200-pin connector. The SAMA5D44 processor from Atmel, based on Cortex-A5 cores, has been equipped. It can work with a maximum frequency of 600 MHz. It has 512 MB of DDR2 SDRAM, 512 MB of NAND Flash memory. GPIO ports, interfaces have been derived on the SO-DIMM 200-pin connector.
No product available!
Module with a button and RGB LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020049
No product available!