- Out-of-Stock
New products
New products New products
Available
zł73.14
24h
Available
zł1,049.01
24h
Available
MYIR MYC-C7Z020
ID: 561772
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
Description
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on Cortex-A9 core that can operate at a maximum frequency of 667 MHz and Artix-7 FPGA. The board is equipped with 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board has numerous peripherals: 10/100/1000 ethernet, external Watchdog or LED diodes. The GPIO outputs, ADC USB OTG 2.0 inputs and interfaces (Serial, I2C, SPI, CAN BUS) have been output on two 140-pin connectors.
properties
- SOC - XC7Z020 (Xilinx Zynq-7010/7020)
- Dual core processor based on Cortex-A9 (667 MHz)
- Integrated Artix-7 FPGA
- 28 thousand logical cells, 17600 LUT, 80 DSP patches (for XC7Z020)
- 85 thousand logical cells, 54200 LUT, 220 DSP patches (for XC7Z020)
- Memory:
- 1 GB of DDR3 SDRAM (2 x 512 MB)
- 4 GB of eMMC memory
- 32 MB QSPI Flash memory
- Periphery:
- Ethernet 10/100/1000
- External Watchdog
- Three LEDs
- Power status (blue)
- Signaling work of FPGA (red)
- Available to the user (green)
- Two 140-pin connectors (0.8 mm pitch) with pins:
- Gigabyte Ethernet
- USB OTG 2.0
- Two serial ports
- Two I2C
- Two CAN BUS
- Two SPI
- ADC
- SDIO
- Supported system: Linux 3.15.0
- Supply voltage: 5 V (0.5 A)
- Dimensions: 75 x 55 mm
561772
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
SUPERLUMISING MODULAR ILLUMINATOR 3xLED WHITE COLD 60mA - SELF-ASSEMBLY KIT
Retired
No product available!
Guido Grillenmeier, de Jan Clercq
Delivery date unknown
No product available!
No product available!
Starter kit with the Kinetis K32 L2B microcontroller, integrated with the OpenSDA programmer-debugger, LCD display, accelerometer and MEMS magnetometer and USB connector. Conclusions compatible with Arduino. NXP FRDM-K32L2B3
Retired
No product available!
PCB and programmed system for 4-channel infrared switch controlled by any IR remote control. AVT1815 B
Retired
No product available!
Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. SEN-13230
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Side panel with sensors for Totem Mini Lab and Totem Micro Lab sets. The board has a microphone, OLED display, DH11 humidity sensor, NTC thermistor, buzzer and a DC motor control module. Totem TE-SP02-B
Retired
No product available!
A small minicomputer with the SoC Allwinner H5 quad-core system (ARM Cortex-A53). The system has a built-in 16-core Mali450 graphics coprocessor. The computer is equipped with 512 MB DDR3 RAM. There are images of UbuntuCore and Armbian systems available for the computer. NanoPi NEO2
Retired
No product available!
Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1
Retired
No product available!
No product available!
No product available!
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.