8-bit ST7 MCU, 4kB Flash, 256B RAM, Lite Timer with Watchdog, Autoreload Timer with 32-MHz input clock, SPI, 10-bit ADC with Op-Amp, DIP20, RoHS

The liquid flow sensor is made of a plastic body, a flow rotor and a Hall sensor. DFRobot SEN0217

Single-channel DC motor driver that can control the movement of the drive with a supply voltage of up to 36 V and a current consumption of up to 15 A. Controlled by a PWM signal. DFRobot DRI0042

Bright white SMD 3528 LED module. DFRobot DFR0438

TP-LINK TL-WN725N is a mini Nano USB wireless network card operating in the N standard (150Mbps), works with Raspberry Pi and many other SBC, RoHS computers

A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae.

1/9" CMOS VGA (640x480) image sensor with OmniPixel3-HS™ technology. ArduCAM B0070

OV7725 based on Omnivision OV7725 image sensor; low voltage CMOS device provides the full functionality of a single-chip VGA camera and image processor as well as the extraordinary high frame rate and low light performance. It provides full-frame, sub-sampled or windowed 8-bit/10-bit images in a wide range of formats, controlled through the Serial Camera Control Bus (SCCB) interface. ArduCAM U3182

ArduCAM CC3200 UNO Board CC3200 UNO is full featured development board almost like a combination of CC3200 Launchpad plus CC3200CAMBOOST pack from TI while keeping exactly the same size as Arduino UNO and pin out. B0078

Quectel M66 is a compact GSM/GPRS module in an LCC package with support for voice transmission, Bluetooth, and OpenCPU, designed for IoT, remote monitoring, and M2M systems. It enables easy integration in devices with limited space and low power consumption.

Module with 12-bit DAC converter and built-in EEPROM memory. The module is supplied with the voltage from 2.7 to 5.5V, the I2C interface is used for communication. SparkFun BOB-12918

Waterproof soil moisture sensor with analog output. The probe has a pointed tip, which allows it to be easily inserted into the ground. It is supplied with the voltage from 3.3V to 5.5V. DFRobot SEN0308

MP2159GJ, Step-Down Converter, 1A, 6V, 1.5MHz, 17μA IQ, TSOT23-8

Module with a 3-axis accelerometer with a resolution of 13bit (ADXL345), RoHS

Expansion board with L6474 stepper motor driver. It is equipped with a connector compatible with Arduino Uno R3 and STM32 Nucleo. STMicroelectronics X-NUCLEO-IHM01A1

An integrated module combining WiFi, Bluetooth 4.0 and FM radio. It has derived SDIO, UART and PCM interfaces. Ampak AP6335

El-wire is a thin and flexible wire which shines under high voltage. The cord is green, has a diameter of 3mm and a length of 5 meters

Camera module with an OV5642 matrix with a resolution of 5 MPx and a size of 1/4 "with output in JPEG format. The transmission speed in the full resolution of 2592 x 1944 pixels is 15 fps. It is equipped with an M12x0.5 1/4 \'\' lens. The device works with 3.3 V, it communicates via a parallel interface. ArduCam B0020