An integrated module combining WiFi, Bluetooth 4.0 and FM radio. It has derived SDIO, UART and PCM interfaces. The module will be used, among others on mobile devices.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Single-mode Bluetooth low energy module featuring smartBASIC, Lairdtech, RoHS
Bluetooth module v2.0 + EDR (master / slave), controlled by AT + commands with built-in antenna.
The Microchip RN4020 module is an energy-saving Bluetooth v4.1 module with a built-in antenna; transmit power level + 7dBm, AES128 coding
Expansion board with BlueNRG-M0 module compatible with Bluetooth v4.2. It is compatible with the ST morpho connector system (unmounted) and Arduino UNO R3. Communication with the module is via the SPI interface. STMicroelectronics X-NUCLEO-IDB05A2
No product available!
Bluetooth 4.0 module based on the CSR8635 chip designed for Bluetooth audio applications. The module has a built-in antenna and pins for edge connectors.
Evaluation kit with Bluetooth 5.0 Sparkfun Artemis module. Equipped with a microphone, kmaers and accelerometer. SparkFun DEV-16828
Bluetooth 5.0 module based on the BT401 chip. It allows you to send audio and support microSD cards up to 128 GB. DFRobot DFR0781
Evaluation Kit with Bluetooth 5.0 BT401. It is equipped with a microSD slot, microUSB connector and two audio outputs. DFRobot DFR0782
Development board with LoRa Semtech SX1262 module and Apollo 3 Bluetooth 5 integrated in the NM180100 chip. It supports the 868 MHz and 915 MHz bands and Bluetooth Low Energy. It is compatible with the Qwicc system. SparkFun 17506
No product available!
Bluetooth 5.2 and IEEE 802.15.4 communication kit. It uses the STM32WB55RG microcontroller (1 MB Flash, 256 KB SRAM, ARM® Cortex®-M4 and Cortex®-M0 +). STMicroelectronics NUCLEO-WB55RG
Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna, microphone, 3.5 mm audio jack and control buttons
Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm audio jack
Energy-saving Wi-Fi and Bluetooth 5.0 module compliant with the IEEE 802.11 a/b/g/n/ac standard. Ampak AP6256
No product available!
Bluetooth module with integrated HC-08 system. Thanks to the angular pin connector with the bus signals, it is possible to easily connect the module to the contact plate or wires
Powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding. Espressif ESP32-WROOM-32E 32MBit (4MB)
Bluetooth 4.0 BLE module with UART serial interface. Controlled by AT commands, it can be supplied with the voltage from 3.6 V to 6 V. AT-09/HM-10
Board with the Artemis chip, the GNSS ZOE-M8Q module and the Iridium 9603N satellite receiver. It allows you to send and receive short messages with data anywhere in the world. SparkFun WRL-18712
No product available!
Module with SIM868 designed for GSM, GPRS communication and GNSS positioning. It can communicate within the Bluetooth 3.0 standard. SB Components 21895
The module is compatible with the Grove Base Shield and designed to implement a wireless serial connection. It uses Bluetooth 4.0 (BLE) HM-11 and UART communication. Seeed Studio 113020008
An integrated module combining WiFi, Bluetooth 4.0 and FM radio. It has derived SDIO, UART and PCM interfaces. Ampak AP6335