16 Mbit, low voltage, Page-Erasable Serial Flash memory with byte alterability and a 50 MHz SPI bus interface, STM, SO8, RoHS

3.5-inch e-paper display with 800x480 resolution. The display is equipped with the HX8705-B controller. The display is perfect for energy-saving devices, because it does not require power to display the image

ST7 MCU, 8kB Flash, 384B RAM, DIP32, RoHS

Waterproof latching button with a diameter of 12 mm and a height of 25 mm in a stainless steel housing. Yellow color

Waterproof latching button with a diameter of 12 mm and a height of 25 mm in a stainless steel housing. White color

5 mm blue LED. 1000 pieces in the package

Small GPS location module with L80-39 GPS chip, USB and TTL two ports,easy to be used with Raspberry Pi, Arduino, STM32 and other kind of micrcontrollers. The GPS module uses NMEA0183 communication protocol, integrated ultra-small SMA antenna connector. DFRobot TEL0119

Waterproof momentary button with a diameter of 12 mm and a height of 25 mm in a stainless steel housing. Blue color

8-bit ST7 MCU, 4kB Flash, 256B RAM, SOP20, RoHS

GEMMA M0 is an intelligent clothing controller from Adafruit. In relation to the classic GEMMA board, it was equipped with a 32-bit ATSAMD21E18 microcontroller (based on Cortex M0 +). It has GPIO pins, RGB DotStar diode. The board can be powered by a 3.7 V Li-Ion battery (JST connector). Adafruit 3501

BNC Socket to MCX Plug Adapter allows connecting probes with a BNC tip to oscilloscopes with an MCX socket, such as FNIRSI models. With an impedance of 50 Ω, it ensures compatibility with most measurement and RF systems, facilitating the integration of measuring equipment in an electronics workshop.

5 mm green LED. 1000 pieces in the package

5 mm yellow LED. 1000 pieces in the package

The SUNON 80x80x25mm DC axial fan offers quiet and effective operation, reliability thanks to Vapo bearings and the autorestart function, and advanced rotational speed control, which makes it an ideal solution for compact cooling systems. Sunon MF80251V1-1000U-G99

A module with a microSD card slot and a pin connector (2.54 mm pitch). It has a built-in voltage regulator and a voltage level converter. The SPI interface lines are led out on the connector

Adapter from HDMI to VGA with microUSB power input and 3.5mm audio jack, 15cm

BMS system for three Li-Ion cells with a voltage of 12 V. It has the function of charging with balancer, discharging and over-discharge protection. The cells can be charged with continuous current up to 60 A and discharged with current up to 80 A