A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae.

Module with temperature and humidity sensor DHT11. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020011

Ultrasonic distance sensor with a range from 3 to 350 cm. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020010

Expansion board with L6474 stepper motor driver. It is equipped with a connector compatible with Arduino Uno R3 and STM32 Nucleo. STMicroelectronics X-NUCLEO-IHM01A1

32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; up to 10 kB SRAM and 4 kB EEPROM; USB device; USART, LQFP64

TP-LINK TL-WN725N is a mini Nano USB wireless network card operating in the N standard (150Mbps), works with Raspberry Pi and many other SBC, RoHS computers

OV7725 based on Omnivision OV7725 image sensor; low voltage CMOS device provides the full functionality of a single-chip VGA camera and image processor as well as the extraordinary high frame rate and low light performance. It provides full-frame, sub-sampled or windowed 8-bit/10-bit images in a wide range of formats, controlled through the Serial Camera Control Bus (SCCB) interface. ArduCAM U3182

Module with a 12-channel capacitive touch sensor MPR121. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020872

32-bit MCU for automotive applications, Power Architecture (e200z0h), 512 kB Flash, LQFP144, STM, RoHS

Camera module with an OV5642 matrix with a resolution of 5 MPx and a size of 1/4 "with output in JPEG format. The transmission speed in the full resolution of 2592 x 1944 pixels is 15 fps. It is equipped with an M12x0.5 1/4 \'\' lens. The device works with 3.3 V, it communicates via a parallel interface. ArduCam B0020

ArduCAM CC3200 UNO Board CC3200 UNO is full featured development board almost like a combination of CC3200 Launchpad plus CC3200CAMBOOST pack from TI while keeping exactly the same size as Arduino UNO and pin out. B0078

Module with a button, LED diode and a blue cap. DFRobot DFR0029-B

Driver for EPAPIER displays in the form of a HAT overlay for Raspberry Pi computers. The SPI interface is used for communication with the controller. Waveshare e-Paper Driver HAT

Comprehensive development platform for Espressif ESP32 a WiFi-compatible microcontroller and nearly 30 I/O pins. DEV-13907

Module with 3-axis magnetometer MAG3110, I2C, RoHS

Module with a 3-axis accelerometer with a resolution of 13bit (ADXL345), RoHS