The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 20V. PDC004

Yellow LED strip with SMD 5050 diodes. It is powered by 12 V DC, has a length of 5 m and 120 LEDs/m. Protection level IP21

An adapter dedicated to XBee modules. It has UART, USB interface and built-in buttons and LEDs. It provides an easy way for project development and debugging. Waveshare XBee USB Adapter

Carrier board dedicated to Raspberry Pi CM4 modules. It is equipped with two Ethernet connectors, a microSD slot and a USB connector. It allows you to build a small router. DFRobot DFR0767

4-digit 7-segment 0.56 "LED display. Built-in HT16K33 controller allowing communication via I2C bus. Equipped with STEMMA QT connector. Adafruit 5601

Male terminal block, angled, 7-pin. Pitch 3.81mm. Height 7mm. 15EDGRC. Set of 10 pieces

Single-channel SuperSpeed USB 3.0 driver from NXP in the X2QFN12 housing. The 1.8V system supports data rates up to 5 Gbit / s. NXP PTN36221AHXHP

Access line ultra-low-power 32-bit MCU ARM®-based Cortex®-M0+, 64 KB Flash, 8 KB SRAM, 2 KB EEPROM, ADC, LQFP48, RoHS

Akyga AK-OT-05A is a 1.5-meter power cable prepared for quick replacement with Europlug CEE 7/16. Thanks to the special solder, installation is easy, which allows you to quickly replace a damaged cable in everyday devices. Akyga AK-OT-05A

The cable is terminated with USB type C plugs, compliant with Quick Charge 4.0 and Power Delivery standards. LANBERG

Knob with an inner diameter of 6 mm for mounting on a rotary potentiometer. White color

24Wx1 + 7Wx2 Triple Amplifier with DC Volume Control, Clipwatt 19, RoHS

Cable with USB typ A and USB typ C connectors, compatible with Quick Charge 3.0, cable length 1,8m. LANBERG

Module with one 240V/2A relay controlled by 5V with a fuse triggered by a high state. modSSR-1CH-H

The ESC RC controller module is designed for brush motors with a supply voltage from 3.5 to 6 V and a capacity of 1 A

Module with 5V relay and timer. It allows the implementation of delayed switching on or off of the circuit with adjustable time in the range from 1 s to 100 s and from 1 s to 15 min.

Module with a 3.5" TFT LCD display with a resolution of 480 x 320 pixels and a resistive touch panel. It can work with the main boards of Manta M4P/M5P/M8P 3D printers or the PI4B adapter. The SPI interface is used to operate the display, and the bus is used for the touch panel. I2C. The module was designed for 3D printers, but it will also be used in other projects. BIGTREETECH TFT35 SPI V2.1

The power cable with a length of 80 cm with a universal USB connector and a 5.5x2.5 mm tip is versatile, suitable for powering network devices, LED lighting and connecting to various sources, such as computers or DC power supplies. Akyga AK-DC-04

Industrial network switch equipped with 5 Gigabit Ethernet ports. It can operate in full-duplex 10/100/1000M mode. Waveshare Gigabit-Switch-5P (EU)