Category: Extension modules for Raspberry Pi
In this category you can find of shield HATfor Raspberry Pi minicomputers. They allow you to add new functionalities to the Raspberry Pi minicomputer, there are communication modules, motor controllers, LCD displays, adapters, modules with sensors and many more.
Subcategories
There are 316 products.
Module with 17x7 LED matrix display (119 LEDs) designed to work with the Raspberry Pi. It uses the IS31FL3731 driver and communicates via the I2C interface. Pimoroni PIM334
A pin expander designed for Raspberry Pi boards. It is equipped with a standard 40-pin connector for connecting a minicomputer and five sets of 2x20-pin outputs for connecting expansion modules. Pimoroni PIM322
Extension module for Raspberry Pi. The board has 7 RGB LEDs, four 14-segment displays, three single-color LEDs, as well as three touch buttons, a BMP280 sensor and a buzzer. Pimoroni PIM242
TFT LCD driver with DPI interface dedicated to Raspberry Pi. It allows you to operate resistive touch panels. Adafruit 2453
A module with 5 buttons and an RGB diode, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer through the GPIO expander controlled by the I2C interface. Pimoroni PIM301
The module with 6 capacitive touch buttons and LED diodes, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer via the CAP1166 controller, which communicates via the I2C interface. Pimoroni PIM272
A module dedicated to Raspberry Pi power management. It has a built-in RP2040 microcontroller that controls the operation of the device. Waveshare Power Management HAT (B) (EU)
The core of a small robot, either as an auxiliary controller atop a Raspberry Pi base or as a complete control solution on its own. Its Atmel ATmega32U4 microcontroller comes preloaded with an Arduino-compatible bootloader. This version does not include any through-hole components or connectors, allowing for customized assembly or standalone use. Pololu 3118
GNSS module based on the L76B chip that can work with GPS, BDS and QZSS systems. Communication via a UART interface. SB Components 24056
DC motor controller that allows the movement of three drives to be controlled via an I2C interface. Pololu 5073
Module with a 3-color (yellow, black, white) e-Paper display with a diagonal of 2.13" and a resolution of 250x122 px. SPI interface. Pimoroni PIM367
Raspberry Pi Expansion Board, DC Motor / Stepper Motor Driver
Radio module with the RFM69HCW (868 MHz or 915 MHz) system, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4072
Radio module with RFM69HCW 433 MHz chip, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4073
Audio extension module for Raspberry Pi 3 Model B / 2B / B + / A + / Zero W with PCM5122 chip and an IR receiver TSOP34838.
Module with 16-channel IO expander MCP23017 controlled by the I2C interface. Designed for minicomputers Raspberry Pi. Adafruit 4132
Adafruit 2340
Module with e-Paper display, 5.83" diagonal and 600x448 px resolution. Communication via SPI interface. Waveshare 5.83inch e-Paper HAT (C)
Add-on board (also known as a pHAT or bonnet) that adds sensing capabilities to your Coral Dev Board or Raspberry Pi projects. The board provides atmospheric data such as light level, barometric pressure, temperature, and humidity. Coral Environmental Sensor Board
HAT designed for Raspberry Pi minicomputers with a two-channel RS232 converter. Communication is realized via the SPI interface. The overlay uses a standard 40-pin Raspberry Pi connector. Waveshare 2-CH RS232 HAT