Category: Main categories
Subcategories
There are 23205 products.
ST7 MCU, 4kB Flash, 384B RAM, 128B EEPROM, LQFP32, RoHS
10 mm Ultra White LED, 10 degree angle; light intensity 25000 mcd (20mA) (3.2V)
The flexible Raspberry Pi Bumper provides extra protection for your Raspberry Pi 5 while allowing easy access to key features and mounting holes. Raspberry Pi SC1655
Compressed under the influence of liquid gas allowing precise dust removal and use with hard to reach places. MICRO CHIP ELEKTRONIC ART.015
Adapter QFN20 to DIP20 in the form of a PCB. It can be used as an adapter for a programmer, breadboards or prototype structures
The KAmod I2C-IOexp16 module is an extension equipped with 16 programmable digital lines (inputs or outputs), based on the MCP23017 system and controlled via the I2C bus with the possibility of connecting up to 8 modules thanks to addressing. The module works with a voltage from 2 to 5 V, has an interrupt output and allows for a current flow of up to 20 mA on each line
ARK terminal connector with a fuse, 5-pin, pitch 10.00 mm, non-detachable
A large momentary button with a diameter of 100 mm with LED backlight. Red color
The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. Soldered connectors. KApico RP2040
LSF0204PWR, 4-Bit Bidirectional Multi-Voltage Level Translator for Open-Drain & Push- Pull, TSSOP14
KAmodRPi Pico Quad Expander enables simultaneous connection of multiple extensions to Raspberry Pi Pico, providing convenient signal distribution and I2C bus support. The module is intended for projects requiring an extended connection topology and integration of numerous peripherals.
MicroHDMI - HDMI cable in white color, 1 meter long. Intended for use with Raspberry Pi 4 model B and Raspberry Pi 5
KAmod TPS5401 is a compact Step-Down switching regulator based on the energy-efficient TPS5401 chip, providing an output voltage of 3.3 V, 5 V, or 12 V (depending on the version). It supports a maximum continuous current of 0.5 A and a wide input voltage range of 4...42 V, while its 2.54 mm pitch terminals allow for easy mounting.
A bistable button with a diameter of 12 mm and a height of 21 mm. Yellow colour
Silicone cover for the heating block of a V6 type 3D printer. Provides an increase in nozzle temperature stability, especially when cooling by air flow
2p male plug angled for PCBs, 2.54mm thick, tinned, white color. Set of 10 pieces
This universal expansion board for the Raspberry Pi Pico extends GPIO pins to both male and female goldpin connectors and screw terminals with labeled pins, facilitating and accelerating prototyping without the need for soldering
