Category: Main categories
Subcategories
There are 22484 products.
Frequency generator module with Si5351 chip based on 25 MHz quartz. The system has three independent, programmable clock outputs that can generate a clock signal in a wide range from 8 kHz to 160 MHz
Compact tool for debugging and programming STM32 microcontrollers via JTAG / SWD interfaces. STMicroelectronics STLINK-V3MINIE
A set of two 35mm crocodile clips (terminals) with a black and red cover.
A specialized liquid intended for cleaning cartridges and nozzles of all types of inkjet printers. MICRO CHIP ELECTRONIC ART.167
Development board with ESP-WROOM-32 module. It allows communication within the WiFi network and the Bluetooth 4.2 (BLE) standard
THT resistor, 0.25W, 5%, RoHS
2p male plug angled for PCBs, 2.54mm thick, tinned, white color. Set of 10 pieces
10 mm Ultra White LED, 10 degree angle; light intensity 25000 mcd (20mA) (3.2V)
LSF0204PWR, 4-Bit Bidirectional Multi-Voltage Level Translator for Open-Drain & Push- Pull, TSSOP14
Set of 10 pcs. Female-female connecting wires, 25 cm long. CAB_F-F (10-25 V)
VisionSOM-8Mmini is comprised of a powerfull NXP quad core processor (i.MX 8M mini = 4x Cortex-A53 core @ 1.8GHz + Cortex-M4 core @ 400MHz), 2GB LPDDR RAM, 8GB eMMC and Murata WiFi/BT module, 0...70C
SLS23X8MMQC_1800C_02GR_08GE_1WB_C
The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. Soldered connectors. KApico RP2040
The Raspberry Pi 27W USB-C PD power supply, working with Raspberry Pi 5, is based on high-quality Rubycon and Panasonic capacitors, offers a European plug and supports USB Power Delivery 5V/3A, 9V/3A, 12V/2.25A, 15V/1, 8A and a special 5V/5A mode for Raspberry Pi 5. Raspberry Pi SC1408
An active splitter utilizing Power Over Ethernet (POE) technology allows devices to be supplied with 5 V. The POE splitter must be connected to a POE switch, POE midspan or 37 V ~ 57 V and a POE injector for proper operation.
UART - USB converter based on the FT232RL chip with TX, RX, RTS and CTS lines led out to the pin connector, the remaining lines available on solder fields for pin connectors. Micro-USB socket. Voltage supply from 3.3 to 5 V. FT232 USB UART Board (micro)
The KAmod USB-C Adapter Module allows for the connection of a USB-C port to almost any electronic system. The pin header provides only the essential signals, including 5V power and D+ and D- data lines.
10-wire cable, 30 cm long, with a JST PH-2.0 female plug at one end
Silicone cover for the heating block of a V6 type 3D printer. Provides an increase in nozzle temperature stability, especially when cooling by air flow
