Boson Starter Kit for micro:bit - starter kit for micro:bit

Starter kit with micro:bit v2. In addition to the micro:bit v2 board, the set includes a microUSB-USB cable, a battery basket and two AAA batteries. SparkFun DEV-17288

The module with six touch buttons and LED diodes is designed for micro:bit. It uses the CAP1166 driver and communicates via the I2C interface. Pimoroni PIM401

A set for building a smartwatch based on the micro: bit educational module. It consists of an expansion board and a strap

Soil moisture sensor dedicated to micro:bit. It is supplied with the voltage from 3.3 V to 5 V and communicates via an analog signal. SparkFun SEN-15272

Protective case for micro:bit modules designed with protection in mind. It is transparent, has large and legible labels for buttons A and B, and full access to the bottom pins of the micro:bit. Kitronik 56102

The expansion module is designed for micro:bit v2. It is equipped with connectors to which you can attach modules compatible with the Grove standard. Seeed Studio 103100063

Edge Breakout for micro: bit is an expansion board for the micro: bit module. It offers leaded I / O pins on a 3 x 25 pin gold pin connector. There are available anlog entries, GPIO pins, I2C and SPI interfaces, as well as power pins. Edge Breakout for micro: bit

Transparent protective case designed for micro:bit educational modules. SparkFun PRT-17867

Micro: Circular RGB LED is an expansion board designed for use with the micro: bit module. It has been equipped with 24 RGB LEDs, a buzzer and a microphone. The board is supplied with voltage in the range of 3.5 ... 5 V. DFRobot ROB0150

Micro:bit expansion module designed for IoT. The board is equipped with WiFi, a two-channel output for DC motors, 6 IO pins, an I2C, UART interface, a buzzer, RGB diodes and a charging circuit. DFRobot MBT0012

Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16446

Speaker for micro:bit is an expansion module with a loudspeaker designed for micro:bit with volume control and headphone output. Speaker for micro:bit

Multifunctional micro:bit expansion module with built-in Li-Ion battery. The board is equipped with a two-channel DC motor driver, 9 IO pins, I2C, UART interface, buzzer, 4 RGB LEDs and a charging circuit. DFRobot MBT0005

The SparkFun micro:bit Breakout is a board that connects to the BBC micro:bit and expands the capabilities of the development platform by providing access to more pins and allowing for connections to the I²C and SPI buses. This breakout board for the micro:bit’s edge connector allows to connect the micro:bit to breadboards and other sensors, motors, LEDs and more! BOB-13988

The IO expansion module is designed to work with the micro:bit educational board. There are 20 GPIO pins on the board, a buzzer and a voltage stabilization circuit

Kitronik 2708 is a relay module designed to work with the BBC micro:bit, allowing control of higher voltage circuits using signals from the micro:bit. Equipped with an electromagnetic relay, it enables safe switching of external devices such as motors or lighting, making it ideal for projects that require control over larger loads.