gator:soil - soil moisture sensor for micro:bit

The IO expansion module is designed to work with the micro:bit educational board. There are 20 IO pins on the board, a buzzer, audio output and voltage stabilization circuit

The SparkFun micro:bit Breakout is a board that connects to the BBC micro:bit and expands the capabilities of the development platform by providing access to more pins and allowing for connections to the I²C and SPI buses. This breakout board for the micro:bit’s edge connector allows to connect the micro:bit to breadboards and other sensors, motors, LEDs and more! BOB-13988

Edge Breakout for micro: bit is an expansion board for the micro: bit module. It offers leaded I / O pins on a 3 x 25 pin gold pin connector. There are available anlog entries, GPIO pins, I2C and SPI interfaces, as well as power pins. Edge Breakout for micro: bit

Transparent case made of tinted plastic, designed for micro:bit educational modules. Adafruit 4852

Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16446

Prototyping kit dedicated to micro:bit. It offers pin leads, a contact plate, buttons, LEDs and a buzzer. SB Components 22717

Multifunctional micro:bit expansion module with built-in Li-Ion battery. The board is equipped with a two-channel DC motor driver, 9 IO pins, I2C, UART interface, buzzer, 4 RGB LEDs and a charging circuit. DFRobot MBT0005

The Pen Lifter pen holder is a set dedicated to the :MOVE Motor for BBC micro:bit. Thanks to the mounted servo, the holder allows you to raise and lower the pen, which can be controlled using a code. Kitronik 56118

The module with a heart rate sensor and the SpO2 level dedicated to micro:bit. It is based on the MAX30102 chip and communicates via the I2C interface. SparkFun SEN-15271

Micro: Circular RGB LED is an expansion board designed for use with the micro: bit module. It has been equipped with 24 RGB LEDs, a buzzer and a microphone. The board is supplied with voltage in the range of 3.5 ... 5 V. DFRobot ROB0150

The IO expansion module is designed to work with the micro:bit educational board. There are 20 GPIO pins on the board, a buzzer and a voltage stabilization circuit

The expansion module is designed to work with the micro:bit educational board. It allows you to build an electronic piano. SB Components 21482

The module with six touch buttons and LED diodes is designed for micro:bit. It uses the CAP1166 driver and communicates via the I2C interface. Pimoroni PIM401

Transparent protective case designed for micro:bit educational modules. SparkFun PRT-17867

Starter kit for the micro:bit v2. The kit includes an expansion module with Grove connectors, Grove modules with sensors and the necessary accessories. Seeed Studio 110060762

A set for building an interactive teddy bear-shaped pendant based on a micro:bit. It consists of a micro:bit v2 educational module, a scroll:bit module with a matrix display, a lanyard and a battery. Pimoroni PIM362