LP-268 - 40W 12V stereo audio amplifier
ID: 582992
5906623474578
zł57.76
Tax included
zł46.96 tax excl.
Stereo audio amplifier with a power of 40 W (2 x 20 W) powered with the voltage of 12 V. Equipped with an audio input in the form of two chinch sockets and an audio jack 3.5 mm input
Description
Stereo audio amplifier with a power of 40 W (2 x 20 W) powered with the voltage of 12 V. It is equipped with an audio input in the form of two chinch sockets (L and R) and a 3.5 mm audio jack input. Speakers with an impedance of 4 to 8 Ω can be connected to the terminal connectors on the rear of the housing. The amplifier is equipped with three potentiometers to control the volume, bass and treble controls and a switch. The whole thing is closed in a nice, aluminum housing with mounting holes that allow the device to be attached to, for example, speakers.
Features
- Stereo amplifier
- Power: 2 x 20 W
- Audio input: 2 x chinch or 3.5mm Jack
- Output: 4 to 8 ohms
- Aluminum housing
- Power supply: 12 V
- Current consumption: 2 A
- Dimensions: 140 x 98 x 41 mm
582992
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Switched-mode AC Power supply 12V/2A with DC 5.5x2.1 connector and EU plug. It has anti-overload, anti-overvoltage, short circuit protection. Conform to the norm Energy efficiency Level V. Length of output cable is 1.2m
zł43.90
24h
Available quantity: 18
Available
12V/2A Power Supply Unit EU for Odroid HC2
zł40.10
24h
Available quantity: 18
Available
Audio cable with 3.5 mm 3-pin minijack 1,2 m length. LANBERG CA-MJMJ-10CC-0012-BK
zł2.50
24h
Available quantity: 41
Available
Audio cable with 3.5 mm 3-pin minijack and 2x RCA (cinch), 2 m length. LANBERG CA-MJRC-10CC-0020-BK
zł3.51
24h
Available quantity: 13
Available
Other products in the same category (16)
No product available!
The board has a class D amplifier onboard that can drive 2 channels of 4-8 ohm impedance speakers at 20W each. Adafruit 1752
zł103.26
24h
Available quantity: 4
Available
Analog input/output module used for testing the integrated AD/DA function of MCUs
zł18.68
4 weeks
No product available!
Sound terminal expansion board based on STA350BW for STM32 Nucleo
zł194.73
1 weeks
No product available!
Audio module with 8 Ohm loudspeaker and 8002B amplifier. It can be used as a buzzer and also play high-quality sound. The volume is controlled by a potentiometer. DFRobot FIT0449
zł31.78
24h
Available quantity: 81
Available
An audio module with a DAC converter and a stereo amplifier designed to work with the Raspberry Pi. Adafruit 3346
zł68.06
24h
Available quantity: 3
Available
Module with LM386 audio amplifier and loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020001
zł25.26
24h
Available quantity: 2
Available
Single-channel audio amplifier up to 100 W.
zł65.33
24h
Available quantity: 2
Available
A set with a vibration generator designed to transfer sounds through the human skeleton to the auditory center. DFRobot KIT0126
zł134.57
4 weeks
No product available!
Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475
zł95.58
24h
Available quantity: 2
Available
Pmod I2S2 is a module with 24-bit A / C and D / C audio converters derived from standard 3,5 mm Jack connectors. Thanks to them, it is possible to send and receive stereo audio signals using the I2S protocol. Digilent 410-379
zł128.35
24h
Available quantity: 3
Available
Module containing TSH82 operational amplifier from STMicroelectronics. The system has two built-in amplifiers and each of them is available separately on the pins of the board as inverting amplifiers. Sparkfun BOB-14874
zł43.32
24h
Available quantity: 2
Available
LM386 audio amplifier module. It is supplied with the voltage ranging from 4 to 12 V. The set includes an 8 Ω, 0.5 W loudspeaker. DFRobot DFR0064
zł61.97
24h
Available quantity: 1
Available
The Class D digital audio amplifier module has two channels with a power of 15 W and can work with speakers from 4 to 8 Ω. Powered with the voltage ranging from 8 to 26 V. Bluetooth communication
zł29.42
4 weeks
No product available!
The Class D digital audio amplifier module has two channels with a power of 30 W and can work with speakers from 4 to 8 Ω. Powered with the voltage ranging from 8 to 26 V. Bluetooth communication
zł29.67
4 weeks
No product available!
Stereo audio amplifier with a power of 40 W (2 x 20 W) powered with the voltage of 12 V. Equipped with an audio input in the form of two chinch sockets and an audio jack 3.5 mm input
zł57.76
24h
Available quantity: 4
Available
Stereo audio amplifier with a power of 40 W (2 x 20 W) powered with the voltage of 12 V. Equipped with an audio input in the form of two chinch sockets and an audio jack 3.5 mm input