A class A audio amplifier with a single channel with a power of 25 W. It was built on the basis of 2SC5200 transistors, based on the popular design by J. Hood from 1969. The components and workmanship used ensure good sound quality and stable operation. There are two potentiometers on the board to adjust parameters (including static current) necessary for device calibration. The amplifier is powered with the voltage from 12 to 28 V, and the input and output signals are connected to screw connectors.

Manufacturer
Responsible person
Class A power amplifier with two channels, 45 W. Built on the popular J. Hood design from 1969
Class A power amplifier with one channel, 10 W. Built on the popular design of J. Hood from 1969. The set includes 2 pieces for self-assembly
Class A audio amplifier with one channel, 25 W. Built on the popular design of J. Hood from 1969. The set includes 2 pieces
Module of a stereo 24-bit audio converter with I2S interface (TS4657).
BOB-11044 OSHWTPA2005D1 class D audio amplifier module. The chip can work with a loudspeaker up to 1.4 W and 8 Ohm. SparkFun BOB-1104
No product available!
The board has a class D amplifier onboard that can drive 2 channels of 4-8 ohm impedance speakers at 20W each. Adafruit 1752
Sound terminal expansion board based on STA350BW for STM32 Nucleo
No product available!
Audio module with 8 Ohm loudspeaker and 8002B amplifier. It can be used as a buzzer and also play high-quality sound. The volume is controlled by a potentiometer. DFRobot FIT0449
An audio module with a DAC converter and a stereo amplifier designed to work with the Raspberry Pi. Adafruit 3346
Module with LM386 audio amplifier and loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020001
Single-channel audio amplifier up to 100 W.
A set with a vibration generator designed to transfer sounds through the human skeleton to the auditory center. DFRobot KIT0126
No product available!
Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475
Pmod I2S2 is a module with 24-bit A / C and D / C audio converters derived from standard 3,5 mm Jack connectors. Thanks to them, it is possible to send and receive stereo audio signals using the I2S protocol. Digilent 410-379
Module containing TSH82 operational amplifier from STMicroelectronics. The system has two built-in amplifiers and each of them is available separately on the pins of the board as inverting amplifiers. Sparkfun BOB-14874
Class A audio amplifier with one channel, 25 W. Built on the popular design of J. Hood from 1969. The set includes 2 pieces