- Out-of-Stock
ADI-training-board
ID: 576518
The Analog Training Board evaluation and training kit for designers interested in modern analog components from the Analog Devices offer
The Analog Training Board (ATB) is a feature-packed, configurable evaluation and education board designed to test and verify the performance of analog components from Analog Devices.The set is used in the free analog electronics course „LTspice tips & tricks” prepared and published by the MIKROKONTROLER.pl portal.
Dimensions: 90 x 130 x 20 mm
576518
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
This ribbon cable allows you to extend all 30 pins on the 2x15 pin male connector to a 2x15 pin female connector. The ribbon cable allows the pins of the 2x15 female connector on the Analog Discovery 2 to be connected directly to the Basys MX3 for easy signal investigation. Digilent 310-100
zł51.38
24h
Available quantity: 5
Available
Available
A portable testing and measuring device that can transform any space into an electronics laboratory. Equipped with 13 tools incl. oscilloscope, logic analyzer, spectrum analyzer, waveform generator and BNC probes. Digilent Analog Discovery Studio 471-031
zł4,201.78
Delivery date unknown
No product available!
Multifunctional computer attachment with USB type C interface. It can operate as a 2-channel oscilloscope, 16-channel logic state analyser, signal generator or programmable power supply. Comes with BNC adapter and oscilloscope probes and Mini Grabber clips. Digilent 471-060
zł2,115.67
24h
Available quantity: 1
Available
Other products in the same category (16)
The STM8L-DISCOVERY kit with the STM8L152C6T6 microcontroller enables learning to operate ultra-low-power microcontrollers and rapid prototyping of applications. The built-in ST-Link and LCD display make the board a complete tool for developing and testing projects based on STM8L.
Retired
No product available!
Wireless motion sensor and magnetic field with built-in event memory (recorder)
Retired
No product available!
No product available!
NanoPi R6S minicomputer designed by FriendlyElec. It is equipped with a Rockchip RK3588S processor, 8 GB LPDDR4x RAM and 32 GB eMMC Flash memory. It supports microSD cards and works with operating systems such as FriendlyWrt, Android, Debian, Ubuntu, etc. FriendlyELEC NanoPi R6S
Retired
No product available!
Cable with USB type A and lightning connectors, cable length 3m. Lanberg CA-USLM-10CU-0030-BK
Retired
No product available!
No product available!
No product available!
No product available!
Z-turn IO Cape extension board is an extension board for Z-turn series tiles based on Xilinx Zynq
Retired
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
Retired
No product available!
HK 3D Printer-Ultimaker V1.5.7 PCB Main Control Board DIY ( RAMPS Compatible ) (46897)
Retired
No product available!
SBC6000X Single Board Computer, AT91SAM9261
Delivery date unknown
No product available!
Module with a UV ultraviolet light sensor VEML6075. Enables measurement of the level of UVA (320-400nm) and UVB (280-320nm) radiation. It communicates via the I2C bus. SparkFun SEN-15089
Retired
No product available!
No product available!
No product available!
Evaluation kit with RISC-V Dual Core 64bit clocked at 400 MHz. Equipped with a camera, microphones, LCD display and microSD card slot. Everything is closed in a housing. Seeed Studio 102110425
Retired
No product available!
The Analog Training Board evaluation and training kit for designers interested in modern analog components from the Analog Devices offer