Best sellers
There are 16588 products.
Module with an analog gas sensor. It allows you to measure the concentration of NO, NO2 and H2. DFRobot SEN0441
The module with 4 relays, designed to work with the micro:bit. It allows you to control devices with operating parameters up to 120VAC/2A or 24VDC/2A. SB Components 14118
A pin expander designed for Raspberry Pi Pico boards. It is equipped with a standard female connector and two sets of male strips 2x20 pins. SB Components 21314
LED strip with addressable RGB WS2813B diodes on a black PCB. It is powered by 5 V DC, has a length of 1 m and 144 LEDs/m. Protection degree IP65
Industrial DIN Rail Power Supply with 10W power, 12VDC output voltage and 0.84A output current. Mounting on a DIN rail. Built-in overload and short circuit protection. MEAN WELL MDR-10-12
Industrial DIN Rail Power Supply with 10W power, 24VDC output voltage and 0.42A output current. Mounting on a DIN rail. Built-in overload and short circuit protection. MEAN WELL MDR-10-24
Module with a capacitive fingerprint sensor. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 101020713
Single-core, multi-strand wire in yellow silicone insulation. 18AWG thickness, 4m length
Single-core, multi-strand wire in white silicone insulation. 18AWG thickness, 4m length
Industrial DIN Rail Power Supply with 10W power, 5VDC output voltage and 2A output current. Mounting on a DIN rail. Built-in overload and short circuit protection. MEAN WELL MDR-10-5
USB-UART converter based on the CP2102N chip. Compatible with a voltage of 3.3 V, it has been equipped with a USB type C connector. Adafruit 5335
Board with WiFi Espressif ESP32-S2 module and u.FL connector. It offers 4 MB of Flash memory and 2 MB of SRAM and an RGB LED. It is equipped with a STEMMA QT connector. Adafruit 5348
The module with the BS312 PIR sensor, which allows motion detection at a distance from 3.2 to 12 m. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020793
Module with SIM868 designed for GSM, GPRS communication and GNSS positioning. It can communicate within the Bluetooth 3.0 standard. SB Components 21895
A pin expander designed for Raspberry Pi Pico boards. It is equipped with a standard female connector and four sets of male strips 2x20 pins. SB Components 21352
Li-Po battery 3.7V / 750mAh, PCM protection, connector 2 pins, cable length 150mm. Akyga LP403450
The expansion board with the LoRa E22-400T22S module for the Raspberry Pi Pico. It supports the LoRaWAN protocol and allows communication in the 433 MHz frequency band. SB Components 21642
The PMSA003 air quality sensor module to work with the Raspberry Pi Pico. It allows for a analysis of the amount of pollutants in the environment based on the concentration of PM1.0, PM2.5 and PM10 particles. SB Components 21819
The expansion board with the LoRa E22-900T22S module for the Raspberry Pi Pico. It supports the LoRaWAN protocol and enables communication in the 868 MHz frequency band. SB Components 21628
A module with a barcode and QR scanner designed to work with the Raspberry Pi Pico. It allows you to read one-dimensional and two-dimensional codes using the intelligent image recognition algorithm. SB Components 22441