Best sellers

Bipolar stepper motor. It has a resolution of 200 steps/revolution (1.8 ° per step), has a nominal voltage of 7.4 V, and draws a current of 0.28 A per coil. Pololu 1207

Module with a capacitive fingerprint sensor. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 101020713

The LSM6DS33 combines a digital 3-axis accelerometer and 3-axis gyroscope into a single package. The sensor provides six independent acceleration and rotation rate readings whose sensitivities can be set in the ranges of ±2 g to ±16 g and ±125°/s to ±2000°/s, available through I²C and SPI interfaces.

Black polyurethane scooter/skate wheel 100 × 24 mm, works with standard 608 bearings. Pololu 3278

The module with the BS312 PIR sensor, which allows motion detection at a distance from 3.2 to 12 m. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020793

LCD IPS module with a screen diagonal of 1,54" and a resolution of 240x240 pixels. The display has a built-in ST7789 driver and communicates via the SPI interface. The display can also work via the GDI port. DFRobot DFR0649

Module for recording sounds, which can store recordings up to 20 seconds. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 107020007

5 mW red laser diode module displaying a point. It uses the PWM signal for control. It can be supplied with the voltage from 4.8 V to 5.2 V. Adafruit 1056

OS Preinstalled Flash Memory with Android

Shielded FTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCF5-10CC-1000-Y

Module with a relay and WiFi communication. Compatible with ESP-01 or ESP-01S

Camera for Raspberry Pi CM3, CM3+ and NVIDIA Jetson Nano. It was equipped with a Sony IMX477R sensor with a resolution of 12.3MPx and a built-in IR filter. Waveshare IMX477 12.3MP Camera

ACeP e-Paper 7-color display with a diagonal of 5.65" and a resolution of 600×448 px. SPI interface. Without PCB. Waveshare 5.65inch e-Paper (F)

Pulse generator module based on the NE555 system with frequency control using a potentiometer. It is powered with the voltage ranging from 5 V to 12 V

Case for Arduino Mega2560, closed, with access to connectors, black

Module with a TL281 4-channel optocoupler with a maximum collector-emitter voltage of 80 V

MicroMod main module with ESP32 chip. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun WRL-16781

MicroMod main module equipped with Bluetooth 5.0 Sparkfun Artemis. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun DEV-16401

Extension board designed for MicroMod main modules. Equipped with a microSD card slot and connectors with SPI, UART and I2C interfaces. It allows you to log data from peripheral devices. SparkFun DEV-16829