Best sellers
There are 16765 products.
DC-DC Step-Down Converter ME3116AM6G with an output voltage of 5 V, input voltage from 6 to 24 V and a maximum output current of 1 A. Dedicated to the M5Stack modules. M5Stack U125
A set of 20 M2.5 screws with a length of 8mm with Philips head
Servo equipped with metal gear and analogue feedback. It is supplied with the voltage in the range from 4.8 to 7.2 V. DFRobot SER0044
Ethernet transceiver module based on LAN8720 chip. It communicates via the RMII interface. Waveshare LAN8720 ETH Board
Miniature motor type MT64 without gear. The operating voltage ranges from 3 V to 6 V and draws 30 mA at 3 V
Module with a joystick with two analog axes (X and Y axis) with a button (Z axis). The board is equipped with a Grove connector and has analog outputs. Seeed Studio 101020028
The platform is based on the Atmega 32U4 microcontroller with a default Arduino compatible bootloader, 26 O / I ports and a microUSB port. Polol 3145
Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475
STM32 Nucleo development board for STM32 F1 series - with STM32F103RBT6 MCU, 128KB flash memory, STM, RoHS
Ultrasonic distance sensor with a measuring range from 2 to 400 cm. It communicates via a standard interface (Echo, Trigger) or the I2C bus. SparkFun SEN-17777
Module with a gas concentration sensor MQ2, which enables the detection of LPG, butane, propane, methane, alcohol, hydrogen and smoke. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020055
Module with ToF VL53L5CX sensor with a matrix of 64 pixels and a range of up to 4 m. Communicates via the I2C interface. Pololu 3417
A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 104020002
Module with white LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0021-W
Module with red LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0021-R
UART-RS485 converter module. It enables communication of Arduino boards with industrial modules. DFRobot DFR0259
Module with vibration sensor LDT0-028. The board is equipped with a Grove connector and has a digital output. Seeed Studio 101020031
Gravity: Vibration Motor Module is a module with a small vibration motor powered by 5V voltage, controlled by a binary signal (high / low state) or using a PWM signal. DFRobot DFR0440