Gravity: Digital White LED Light - digital module with LED diode (white)

Expansion module for the OpenMV Cam M7 camera. The board has connectors compatible with the Gravity standard. It has digital, analog, serial and I2C pins. DFRobot DFR0578

Module with a button, LED diode and a white cap. DFRobot DFR0029-W

Audio Analyzer is a module with sound analyzer based on the MSGEQ7 system. It divides the sound into seven frequency bands, and then allows you to read the peak levels of each band. It allows you to measure the sound in the following frequencies: 63Hz, 160Hz, 400Hz, 1kHz, 2.5kHz, 6.25kHz and 16kHz. DFRobot DFR0126

Gravity module with a fingerprint reader (capacitive sensor). It uses an efficient processor and the IDfinger6.0 algorithm. It ensures quick identification and stability of operation, communicates via the I2C interface. DFRobot SEN0359

Module with an analog current sensor. It enables the measurement of AC and DC current up to 50 A. DFRobot SEN0098

8-digit, 8-segment LED display module with 16-level brightness adjustment. Communication via the I2C interface. DFRobot DFR0646-G

Module with temperature and humidity sensor DHT11. It allows you to measure humidity in the range of 20 ... 90% and temperature (0 ... 50 ° C). DFRobot DFR0067

Module with an analog sensor of carbon monoxide and combustible gases (methane, propane) MQ9. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0134

Module with an ozone detection sensor that performs measurements in the range of up to 10 ppm with a resolution of 0.01 ppm. The module is equipped with an I2C interface. DFRobot SEN0321

Gravity: Digital LED String Lights (Colorful) consist of a series of colored LEDs. It is powered by a voltage of 2.5 ... 5 V and consists of 40 LEDs placed on a 4-meter cable. DFRobot DFR0439

An expansion board designed for FireBeetle M0 and ESP32-E kits. The board has 12 GPIO pins, 5 ADC, UART, I2C and SPI interfaces. The pins are color coded according to the Gravity standard. DFRobot DFR0762

A set with a measuring module and a probe for measuring the pH of the solution. It is supplied with the voltage of 3.3 to 5.5 V. It has an analog Gravity output interface. DFRobot SEN0161-V2

Module with a miniature DC motor. No additional controller is required to start the engine. The module is controlled by the PWM signal. DFRobot DFR0411

Gravity: I2C 12-Bit DAC is a module with 12-bit DAC and built-in EEPROM memory. The module is powered by 3.3 ... 5V for communication used by the I2C interface. DFRobot DFR0552

Module with a buzzer (without generator) controlled by a digital interface. It allows you to generate simple sounds by changing the frequency of the control signal. DFRobot DFR0032

A sensor that detects the concentration of hydrogen chloride. Equipped with a factory calibrated probe. It communicates via the I2C interface, UART or analog output. DFRobot SEN0474