Best sellers

A set of two alligator clip connectors (clamps) in the form of sockets for multimeter probes. Supplied with a black and red cover

Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table. Set of 4 pcs

Flexible RGB 8x8 LED Matrix Module with Addressable WS2812B LEDs. modFlexMatrix8x8

Dispensing needle for precise application of glue, flux with an internal diameter of 0.25mm and an external diameter of 0.5mm. Set of 5 pieces

Female terminal block, 8-pin. 3.5 mm pitch. Height 15.6 mm. GOLTEN 15EGTK-3.5-08P-14-00AH. Set of 5 pcs

Set of 10 cables, 30 cm long, for analog sensors compatible with the Gravity standard. DFRobot FIT0031

Male terminal block, angled, 3-pin. Pitch 3.81mm. Height 7mm. 15EDGRC. Set of 10 pieces

Tape, in the form of a braid, for removing excess melted solder when soldering and desoldering electronic components, 1.5 m

ESC controller module for a brushless motor with a current capacity of up to 80 A. It can work with LiPo packs from 5S to 12S. Uses BLHeli_32 software. FLYCOLOR X-CROSS HV

The 7A 1-2S BLheli_S XSD7A Miniature Brushless Motor ESC Controller is a compact, high-performance device ideal for controlling brushless motors in small projects. Thanks to its low weight and solid power, it is suitable for drones, RC models and other applications requiring precise motor control.

Module with a PIR motion sensor. It can detect movement up to 7 meters with a detection angle of 100 degrees. DFRobot SEN0171

A high-efficiency UBEC switching regulator for powering receivers and servos in RC models with 2–8 S LiPo batteries. It provides a stable voltage of 5.25 V with a load of up to 5 A, with power reserve for temporary overloads, ideal for large models requiring a reliable power source.

A lightweight UBEC regulator for RC systems powered by 2–6 S LiPo batteries. It provides 5.25 V at a continuous current of 3 A, with a reserve for temporary overloads. It ensures stable power supply for electronic components in models with limited space and weight.

The Step-Down 4A 3.3V/5.2V converter module is a compact device with a large input voltage range, enabling precise conversion to 3.3V or 5.2V output with low static power consumption and low output noise. Perfect for powering electronic projects and microcontroller circuits, offering stability and performance.

Module designed to filter electrical signals. It uses an LC filter, which consists of a coil and a capacitor, to eliminate noise and unwanted components from the electrical signal. It can filter signals with voltages up to 30 V and currents up to 3 A

A universal calibrator that allows both simulation and measurement of various electrical and thermal parameters. It is able to emulate thermocouple signals and enables accurate measurement of direct voltage (DC), resistance and current, as well as testing and calibration of thermocouples and Pt100 and Cu50 thermoresistance sensors. LB02

Digital signal generator with one output channel. It supports wave types such as sine wave, square, triangle or sawtooth signals and offers generated signal frequencies up to 500 kHz. FG-100

Programming module for AM32 and BLS32 series ESC controllers. It allows you to easily update the controller software via the USB Type-C connector. RhinoESC Crawler

Module with an ozone detection sensor that performs measurements in the range of up to 10 ppm with a resolution of 0.01 ppm. The module is equipped with an I2C interface. DFRobot SEN0321