Best sellers

The quartz heater is used for preheating the PCB using quartz glass, prevents overheating and damage during soldering. WEP 853A

Soldering iron with smooth regulation of digitally controlled air discharge, with temperature regulation in the range of 100 ° C to 500 ° C

Bipolar stepper motor. It has a resolution of 200 steps/revolution (1.8 ° per step), has a nominal voltage of 7.4 V, and draws a current of 0.28 A per coil. Pololu 1207

The Pololu Pushbutton Power Switches are sophisticated power control alternatives to bulky mechanical switches. The main function is pushbutton-based latching power control, where one push turns on power and another push turns it off.

The LSM6DS33 combines a digital 3-axis accelerometer and 3-axis gyroscope into a single package. The sensor provides six independent acceleration and rotation rate readings whose sensitivities can be set in the ranges of ±2 g to ±16 g and ±125°/s to ±2000°/s, available through I²C and SPI interfaces.

At the Feather M0\'s heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic, the same one used in the new Arduino Zero. This chip has a whopping 256K of FLASH (8x more than the Atmega328 or 32u4) and 32K of RAM (16x as much). Adafruit 2796

At the Feather M0\'s heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic. 256K FLASH, 32K RAM, built in USB and battery charging. Adafruit 2772

Machine Screw: #2-56, 7/16" Length, Phillips (25-pack)

Module with 8 inputs for data acquisition from DS18B20 temperature sensors. It communicates via the RS485 interface and supports the Modbus RTU protocol. The board is enclosed in an industrial housing. Wellpro WP3066ADAM

Module with 16 digital inputs. It communicates via the RS485 interface and supports the Modbus RTU protocol. The board is enclosed in an industrial housing. Wellpro WP8026ADAM

Module with 8 digital inputs and 8 digital outputs. It communicates via the RS485 interface and supports the Modbus RTU protocol. The board is enclosed in an industrial housing. Wellpro WP8028ADAM

10.1" IPS LCD display with touch panel. Equipped with RGB888 parallel interface for image display and I2C for touch panel operation. Waveshare 10.1inch Capacitive Touch LCD (F)

Tamiya 70188 Mini Motor Gearbox (8-Speed) Kit

The Terasic LT24 is a 2.4” LCD touch module with 240(H) x 320(V) display resolution. It can be bundled with various Terasic FPGA development boards through the 2x20 GPIO interface. P0185

Module with 4 digital inputs, 4 outputs and 6 analog (current) inputs. It communicates via the RS485 interface and supports the Modbus RTU protocol. The board is enclosed in an industrial housing. Wellpro WP9038ADAM

Board with prototype holes dedicated to Raspberry Pi Pico. It offers an 8x20 hole area with a pitch of 2.54 mm with marked pin labels and a reset button and STEMMA QT connector. Adafruit 5200

A set containing a Tamiya motor with a speed of 10500 rpm, an attacking gear, a double-sided tape and a vinyl tube. Pololu 1688

KD3005D is a stabilized power supply with smooth voltage regulation in the range from 0 to 30V and smooth current regulation in the range from 0-5A