Best sellers

A new version of the popular mono amplifier kit, capable of amplifying audio from any source, such as MP3 players, using the NCP2890 with an output power of up to 1 W. The kit comes pre-assembled, including a jack cable, 8Ω speaker, and a battery holder for two AA batteries, allowing for quick start-up and ideal for portable DIY audio projects. Kitronik 2165B

Universal EEPROM, PROM, NVRAM, SPLD, CPLD, EPLD and MCU memory programmer. It is controlled from the computer via the USB interface and software for Windows systems. Xeltek Superpro 610P

Adapter with built-in Power Delivery (PD) trigger. It has a USB type C socket and a 5.5x2.1 mm DC plug

Adapter with built-in Power Delivery (PD) trigger. It has a USB type C socket and a 4.5x3.0 mm DC plug. Maximum power up to 100 W

The driver with the TPIC6C596 system allows you to control 7-segment displays using three signal lines. Serial connection of controllers is possible. SparkFun WIG-13279

Slim 3V battery powered LEDs that are perfect for e-textile projects. With clearly marked connectors and double-sided PCB, these LEDs are easy to connect and highly durable, making them the perfect choice for interactive clothing, accessories and decorations that combine fashion with modern technology. Kitronik 2714

This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V. SEN-13285

X-NUCLEO-IDS01A4 is a development board STM32 Nucleo that allows the use of the RF SPSGRF-868 module for the ISM band (868 MHz carrier).

Light-sensing Infrared LED Board

FLORA is Adafruit\'s fully-featured wearable electronics platform. It\'s a round, sewable, Arduino-compatible microcontroller designed to empower amazing wearables projects. Adafruit 659

Intelligent relay cooperating with iNode Control ID

Intelligent RFID identifier cooperating with iNode Control Point

Unshielded UTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCU5-10CC-1000-B

Low Energy Bluetooth adapter module with 2x4 pin 2.54mm connector, extra / high. RS232 allows communication with BLE devices

Low Energy Bluetooth adapter module with USB 2.0 connector. allows communication with BLE devices

Programmable wireless BT4.0 transmitter, compatible with sensors of the iNode Care Sensor series. It allows you to enable / disable other devices, eg after exceeding the set temperature or humidity, moving the sensor or changing its position. Allows you to control directly from your smartphone, tablet or computer