Best sellers
There are 17376 products.
Module with digital temperature sensor TMP117. It enables temperature measurement in the range from –55°C to 150°C with very high accuracy up to ± 0.1°C. The system communicates via the I2C interface. SparkFun SEN-15805
32-bit microcontroller with ARM Cortex-M4 core MCU + FPU, Ultra-low-power, 2MB Flash memory, 640KB SRAM, LCD-TFT & MIPI DSI, ext. SMPS, LQFP100
REBEL adhesive insulation tape measuring 0.13 mm x 19 mm x 20 yards (approx. 18.3 m) in red color is designed for wire marking, insulation, and securing components during everyday repairs. Its flexibility and durability provide effective protection in various electrical and mechanical applications.
This ribbon cable allows you to extend all 30 pins on the 2x15 pin male connector to a 2x15 pin female connector. The ribbon cable allows the pins of the 2x15 female connector on the Analog Discovery 2 to be connected directly to the Basys MX3 for easy signal investigation. Digilent 310-100
Wind meter with temperature measurement function. The device can measure wind speed up to 30 m/s and wind temperature from -10 to 50℃. Uni-T UT363
Graphite grease owes its usefulness to a carefully selected mixture of ingredients of the highest quality. AG Termopasty ART.AGT-079
Mains socket with an electricity consumption meter. It is used to monitor the operating status (voltage, current, time and power consumption) of electrical devices. Uni-T UT230B-EU
Adafruit 16-Channel PWM / Servo HAT for Raspberry Pi - Mini Kit (Adafruit 2327)
Module with 3-axis magnetometer MAG3110, I2C, RoHS
HDMI 3.5 "480 x 320 pixel color LCD module with touch panel for Raspberry Pi. Waveshare 3.5inch HDMI LCD
AG Double-sided adhesive, thermally conductive thermopads are used where it is not possible to use thermally conductive paste. They are very flexible. They are characterized by high compressibility which ensures a good fit to elements that require cooling. AG Termopasty ART.AGT-135
Module with ACS724LLCTR-05AB current sensor with a measuring range of direct and alternating current from -5 to 5 A. It communicates via an analog interface. Pololu 4041
Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 5A. DFRobot SEN0287
HDMI / micro HDMI plug-in cable (AD) from Kruger & Matz, allows you to connect the latest generation of Micro HDMI devices to displays equipped with an HDMI connector. KM0327
FRAM chip has 64 Kbits (8 KBytes) of storage, interfaces using SPI, and can run at up to 20MHz SPI clock rates. Each byte can be read and written instantaneously (like SRAM) but will keep the memory for 95 years at room temperature. Adafruit 1897
Detector allowing for non-contact voltage detection. It has two operating modes: low voltage and high voltage for checking three-phase and industrial installations. Uni-T UT12E-EU
Gravity: IO Expansion & Motor Driver Shield is an Arduino compatible expansion board that provides digital I / O ports, analog I2C, SPI and UART interfaces, as well as a DC motor driver. DFRobot DFR0502
The S9V11F3S5C3 switching step-up/step-down regulator efficiently produces a fixed 3.3 V (default) or 5 V (selectable) output whether it is higher or lower than the input voltage, which can range from 3 V to 16 V. The regulator also has fixed 3.3 V low-voltage cutoff with hysteresis that can be used to prevent battery over-discharge.