Best sellers
There are 17478 products.
IoT development board equipped with ESP32 chip with WiFi and Bluetooth, has a USB-UART interface allowing programming via the USB port of the computer. DFRobot DFR0625
8 Mpx camera module with IMX219 sensor. The camera is intended for use as a replacement on the RPI Camera Board V2. ArduCAM B0180
Camera module with OV9282 sensor designed for DepthAI systems, including the DM1090FFC base board. ArduCAM B0334
2x16 LCD Module (No Backlight)
1.8 "TFT display module with SD slot. The module is based on the ST7735S controller, SPI interface. It has support in the form of libraries for Arduino and STM32. MSP1804
Module with five reflection sensors. It has digital and analogue outputs. Thanks to the embedded EEPROM memory, it enables easy sensor calibration. Cytron Maker Line
Development kit intended for creating Bluetooth Low Energy, Bluetooth mesh, Thread, Zigbee, 802.15.4, ANT applications. It has a built-in SEGGER J-Link debugger enabling programming and debugging. Nordic Semiconductor nRF52840-DK
Module with BME680 sensor to measure the concentration of volatile organic compounds, pressure, temperature and humidity. It communicates via the I2C interface. Pimoroni PIM357
Module with a light sensor and a proximity sensor up to 5 cm. It allows you to read the illuminance from 0.01 to 64000 lux and communicates via the I2C interface. Pimoroni PIM413
A set of 5 test clips with leads terminated with pins. Digilent 240-137
Single-channel DC motor controller that allows the motor to be controlled with a voltage range of 6-30V and a current of up to 20A. Allows engine speed control using PWM signals. MD20A cytron
A 20 cm long 3-pin cable with a JST XH2.5 male plug on one side
DC-DC Step-Down converter module AP63203 with an output voltage of 3.3 V, an input voltage of 3.8 to 32 V and a maximum output current of 2 A. SparkFun COM-18356
STM32 Nucleo-144 development board with STM32F722ZE MCU, supports Arduino, ST Zio and morpho connectivity
Development board FPGA PYNQ-Z1 and accessor set. Includes base plate, power supply, cables and SD card with system image for PYNQ-Z1. Digilent 240-114-1
Module with 7 QTR type optocoupler with RC (digital) output. The module operates from 2.9 V to 5.5 V, detects objects at a distance of up to 40 mm. The sensor will be used in projects that require detection of changes in the ground, e.g. in linefollower robots. Pololu 4147