Best sellers

Micro 5.1:1 planetary gear motor, standard operating voltage 6V, speed 13,000 rpm and torque 0.02 kg*cm (0.3 oz-in). Pololu 2331

Module with 25 QTRX type optocoupler with analog output. The module operates from 2.9 V to 5.5 V, detects objects at a distance of up to 50 mm. The sensor will be used in projects that require detection of changes in the ground, e.g. in linefollower robots. Pololu 4425

Evaluation board with nRF52840 microcontroller and bluetooth communication. Equipped with motion, temperature, light, sound sensors and RGB diodes. Can be programmed in CircuitPython or Arduino IDE. Adafruit 4333

Module with a temperature and humidity sensor based on the SHT40 system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4885

Module with light intensity sensor TSL2591. Equipped with STEMMA QT connector with I2C interface. Adafruit 1980

Module for 4 mechanical buttons with LED backlight in the form of NeoPixel diodes. Communicates via I2C. Adafruit 4980

Iridium 9603N satellite receiver module. It allows you to send and receive short messages from anywhere on Earth and works far beyond the range of WiFi and GSM networks. SparkFun WRL-14498

The Taoglas AA.200 MagmaX2 GNSS multi-band antenna with magnetic mounting. It is designed for use with most major positioning systems, including GPS, GLONASS, Galileo and BeiDou. SparkFun GPS-17108

Cable with USB type A and microUSB type B plugs, length 1m, white

A small gripper designed for small robotic arms. It is designed for use with a servo (not included). The kit is easy to assemble. SparkFun ROB-13176

Two-channel DC motor driver powered with the voltage from 2.5 to 12 V with a maximum continuous current of 0.8 A per channel. It can control a bipolar stepper motor

Surface loudspeaker with an impedance of 4 Ω and a power output of 10 W. It is constructed with a coil attached to a pad that conducts vibrations. SparkFun COM-19102

Universal charger with dual charging sockets designed for Li-Ion, LiPo, LiFe, LiHV, Pb and Ni-MH batteries. It has a power output of up to 500 watts, allowing up to 25 amps of charging current. ToolkitRC M6D

Two-channel driver for DC motors with an operating voltage from 7 to 45 V and a continuous current of up to 60 A. It can be controlled by an analog signal, PWM, UART, RC or by means of built-in buttons. Cytron MDDS60

A probe for measuring AC and DC currents up to 650 A. It operates in a bandwidth of up to 400 Hz and can be connected to an oscilloscope via a BNC connector. Hantek CC-650

A probe for measuring AC and DC currents up to 65 A. It operates in a bandwidth of up to 20 kHz and can be connected to an oscilloscope via a BNC connector. Hantek CC-65

Pad dedicated to 3D printing. It has dimensions of 220x220 mm and is covered with a PEI coating on one side

Pad dedicated to 3D printing. It has dimensions of 220x220 mm and is covered with a PEI coating on both sides

Cable with USB type A and microUSB type B plugs, length 2m, white

Cable with USB type A and USB type C plugs, length 2m, white