Best sellers

Knife with a 9mm blade by YATO YT-75003.

The expansion module is designed for micro:bit board. Controller: bit offers a fully functional controller module with a design based on a classic Nintendo controller. SparkFun DEV-16129

A mini module with a Qwiic connector designed for Raspberry Pi minicomputers. Qwiic SHIM uses a unique connector that snaps into the GPIO connector for a secure, solder-free connection. SparkFun DEV-15794

Li-Po battery with a rated voltage of 3.7 V and a capacity of 110 mAh, equipped with a PCM protection and a 2.5 JST-RCY connector. Akyga LP401230

Module with LCD display 16x2 characters with blue backlight. It is supplied with the voltage from 3.3 V to 5 V and communicates via the I2C interface. DFRobot DFR0555

Module with a flexible e-Paper display with a diagonal of 2.9" and a resolution of 296x128 px. Communication via the SPI interface. Waveshare Pico-ePaper-2.9-D

The board is equipped with the STM32F405 microcontroller with the ARM Cortex-M4 core and SPI Flash memory, 20 GPIO pins, SD card slot, pins for connecting the battery with the charging and voltage stabilization circuit, JTAG connector and Qwiic socket. SparkFun DEV-17712

SoM Raspberry Pi CM4 with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5 GHz, 2 GB LPDDR4 RAM and 8 GB eMMC. Raspberry Pi CM4002008

A set of three cables for Grow soil moisture sensors. The cables are terminated on both sides with 3-pin JST-SH female connectors and are 35 cm long. Pimoroni CAB1006

Silicone tube with an internal diameter of 5 mm and a length of 1 m for the Grow water pump. It will work in home automatic irrigation systems. Pimoroni COM3800

WiFi 802.11 b/g/n module with ESP8266 chip, there are 8 pins with UART and GPIO interface. Built-in PCB antenna. SparkFun WRL-17146

Energy consumption meter designed for 3-phase installations. It allows you to monitor electricity consumption and supervise the amount of energy generated, for example, by solar panels. Shelly 3EM

Panel light controller with WiFi function. Equipped with a brightness adjustment function. It has been designed for installation in a flush-mounted box and can work with any type of light bulb. Shelly Dimmer 2

Starter kit from the NUCLEO series equipped with the STM32H723ZG microcontroller (1 MB Flash, Cortex-M7), with a built-in programmer-debugger ST-Link/V3, equipped with connectors compatible with Arduino. STMicroelectronics NUCLEO-H723ZG

MicroMod main module with STM32 microcontroller. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SparkFun DEV-17713

Module with blue LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0031-B

A mini water pump with a capacity of 240 l / h designed for home automatic irrigation systems. It is immersed in water, powered by 12 V and has a power of approx. 5 W

Analog voltage divider module. It enables a 5-times reduction of the input voltage. DFRobot DFR0051

Module with green LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0021-G

Set for IR communication. It consists of an IR receiver module and a remote control. DFRobot DFR0107