SparkFun Thing Plus - board with STM32 microcontroller
search
  • SparkFun Thing Plus - board with STM32 microcontroller
  • SparkFun Thing Plus - board with STM32 microcontroller
  • SparkFun Thing Plus - board with STM32 microcontroller
ID: 586262
5906623418169
zł149.38
Tax included

zł121.45 tax excl.

The board is equipped with the STM32F405 microcontroller with the ARM Cortex-M4 core and SPI Flash memory, 20 GPIO pins, SD card slot, pins for connecting the battery with the charging and voltage stabilization circuit, JTAG connector and Qwiic socket. SparkFun DEV-17712

24h
Available
Available quantity: 2
Kamami is the official distributor of Sparkfun modules and development kits. All products of this brand in our offer are original and come directly from the manufacturer.

Description

SparkFun Thing Plus is a board equipped with an STM32F405 microcontroller with an ARM Cortex-M4 core operating at a frequency of up to 168 MHz. On the board compatible with Feather, apart from the STM32 chip and SPI Flash memory, the user will find 20 GPIO pins, SD card slot, pins for connecting the battery with the charging and voltage stabilization circuit, JTAG connector and Qwiic connector.

Programs can be loaded to memory via the USB interface using the built-in DFU bootloader. The guide with examples of use is available on the product page.

Features

STM32 General Features:

  • ARM® 32-bit Cortex®-M4 CPU with FPU
    • Adaptive real-time accelerator (ART Accelerator™) allowing 0-wait state execution from Flash memory
    • Frequency up to 168 MHz
    • Memory protection unit
    • 210 DMIPS/ 1.25 DMIPS/MHz (Dhrystone 2.1)
    • DSP instructions
  • 1 Mbyte of Flash memory
  • 192 Kbytes of SRAM including 64 Kbytes of CCM (core coupled memory) data RAM
  • Flexible static memory controller supporting Compact Flash, SRAM, PSRAM, NOR and NAND memories
  • Clock, reset and supply management
    • 1.8 V to 3.6 V application supply and I/Os
    • 32 kHz oscillator for RTC with calibration
    • Internal 32 kHz RC with calibration
  • Low-power operation
    • Sleep, Stop and Standby modes
    • VBAT supply for RTC, 20×32 bit backup registers + optional 4 KB backup SRAM
  • Debug mode
    • Serial wire debug (SWD) & JTAG interfaces
    • Cortex-M4 Embedded Trace Macrocell™
  • Advanced connectivity
    • USB 2.0 full-speed device/host/OTG controller with on-chip PHY
    • USB 2.0 high-speed/full-speed device/host/OTG controller with dedicated DMA, on-chip full-speed PHY and ULPI
    • 10/100 Ethernet MAC with dedicated DMA: supports IEEE 1588v2 hardware, MII/RMII

Specific Peripherals available on STM32 Thing Plus:

  • UART bus
  • I2C Bus
  • SPI bus
  • Up to 15 Analog Inputs, Two Analog Outputs
  • 20 Digital I/O Pins, 14 PWM Capable
  • SDIO for microSD card support
  • JTAG Serial Wire Debug Support
  • Power Select
  • LiPo Charging Circuit
  • 3.3V Regulator
  • 128 Mbit SPI Flash
586262

Data sheet

Microcontroller
STM32F405
Flash memory
1 MB
Number of I/O
20
Ethernet
100Mb x1
WiFi/BT module
No
Bluetooth module
No
MicroSD slot
No
Length
58,4 mm
Width
22,8 mm
USB connector type
USB type C

Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

You might also like

Other products in the same category (16)